Physics

posted by .

A pulley system lifts a 500-lb block 1.0 foot with an effort of only 50 lb. If the 50 lb moves 30 feet, calculate the efficiency of the pulley system.

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. physics

    You exert a force of 455N in pulling 15.0m of rope using a pulley system to lift a 935N object 5.0m. What is the efficiency of the pulley system?
  2. physics

    The system shown in the figure below consists of a m1 = 5.52-kg block resting on a frictionless horizontal ledge. This block is attached to a string that passes over a pulley, and the other end of the string is attached to a hanging …
  3. physics

    The system shown in the figure below consists of a m1 = 5.52-kg block resting on a frictionless horizontal ledge. This block is attached to a string that passes over a pulley, and the other end of the string is attached to a hanging …
  4. physics

    The system shown in the figure below consists of a m1 = 5.52-kg block resting on a frictionless horizontal ledge. This block is attached to a string that passes over a pulley, and the other end of the string is attached to a hanging …
  5. Physics

    calculate the acceleration of this system, assuming that there are no frictional forces between the table and Block A. Block A is sitting on a table connected by a rope to a pulley system and Block B is hanging off the table connected …
  6. mabathoana high school maseru

    A block and tackle system of 5 pulley is used to raise a load of 500N steady through a height of 20m the work done against friction is then 2000J. Calculate the work done By effort, efficiency and effort applied
  7. Physics

    A block and tacle of 6 pulley is used to raise a load of 300n steadily through a height of 30m if the workdone against friction is 2000j. calculate the workdone by the effort,the applied effort,the efficiency of the system
  8. Physics

    A pulley system has a velocity ratio of 4 and an efficiency of 80%.calculate the value of the effort required to raise the load of 480N
  9. Physics

    Suppose you have a system of two masses strung over a pulley. Mass 1 (6.5 kg) hangs on the right side of the pulley suspended over the ground at height 1 m. Mass 2 (2.2 kg) hangs over the left side of the pulley and rests on the ground. …
  10. value

    An Effort Of 250N Raises A Load Of 1000N Through 5m In A Pulley System.If The Effort Moves 30m,what Is; (a)the Work Done In Raising The Load (b)the Work Done By The Effort (c)the Efficiency

More Similar Questions