Mathematics Ms Sue help

posted by .

A high pass filter with a cutoff frequency of 250 kHz is placed in a circuit after a low pass filter with a cutoff frequency of 150 kHz. Together, these filters create which type of filter?

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. electrical engineering

    Instructions The goal of this project is to design, simulate, build and test a simple speaker system that can connect to a portable audio device such as an mp3 player or laptop. The system has the following requirements: ยง Accept …
  2. Physics

    If the critical frequency of a low-pass filter is 5 kHz, what is the filter bandwidth?
  3. Circuits

    How do I design a low pass filter for an Fc = 4000 Hz and a high pass filter for Fc =2000 Hz?
  4. Physics

    What is the center frequency of a filter with a Q of 15 and bandwidth of 1.0 kHz?
  5. physics

    (a) A vertically polarized photon goes through two polarizing filters, the first of which is vertically aligned and the second at degrees. What is the probability that the photon is transmitted through both filters?
  6. Physics

    The capacitance in a series RCL circuit is C1 = 1.2 μF, and the corresponding resonant frequency is f01 = 7.2 kHz. The generator frequency is 1.2 kHz. What is the value of the capacitance C2 that should be added to the circuit …
  7. Electronics

    Is a circuit a bandpass filter only when it's a high pass filter followed by a low pass filter?
  8. Science

    Design of a fourth order low pass filter with 150 Hz frequency for ecg acquisition
  9. Math

    Ten analog measurements whose bandwidth is 4 kHz are to be transmitted simultaneously through a cable by time division multiplexing using PCM. Each message is sampled at a 10 kHz rate and amplitude quantized into 128 levels. The pulses …
  10. math

    Janine is considering buying a water filter and a reusable water bottle rather than buying bottled water. Will doing so save her money?

More Similar Questions