chemistry

posted by .

draw particle diagrams that account for the fact that 2 volumes of nitric oxide gas react with 1 volume of oxygen gas to form 2 volumes of product with no leftover gas

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. chemistry

    the composition of hydrogen selenide can be determined by heating tin(Sn)in a measured volume of gas the hydrogen selenide is decomposed producing solid tin selenide(SnSe)and hydrogen gas if the temp,and pressyure are unchanged,the …
  2. Chemistry

    The van der Waals equation for real gases recognizes that (A) the molecular atrractions between paritcles of a gas decreases the pressure exerted by the gas (B) the non-zero volumes of gas particles effectively decrease the amount …
  3. Chemistry

    1. You have gone back in time and are working with Dalton on a table of relative masses. Following are his data: 0.602g gas A reacts with 0.295g gas B 0.172g gas B reacts with 0.401g gas C 0.320g gas A reacts with 0.374g gas C a) Assuming …
  4. CHEM

    Could you please tell me if these are right?
  5. Chemistry

    A hydrocarbon gas burned completely in O2 to give CO2 and H2O.It was found that one volume of hydrocarbon gas at STP produced two volumes of CO2 and three volumes of steam corrected at the same temperature and pressure. What is the …
  6. chemistry

    Nitrogen and oxygen react to form nitric oxide (NO). All substances are in the gas phase. If 0.352 atm of nitrogen and 0.511 atm of oxygen react, what is the partial pressure of nitric oxide (in mmHg) when this reaction goes 73.9 complete. …
  7. Chemistry

    Use molar gas volumes to convert the following gas volumes to amount in moles. A) 1.5 L of carbon monoxide gas at SATP B) 21.5 L of fluorine gas at STP
  8. Chem

    A scientist finds that one volume of an unknown gas X combines with 2 volumes of another gas Y to form 2 volumes of a new gas with a formula XY2. What is the balanced equation?
  9. Chemistry

    Ok so I realize this is a lot of questions, but if someone could at least just give me the general set up for each problem that would save my life! In each of the four problem in this section, all gases are measured at the same temperature …
  10. Chemistry

    I posted this before and I know now to use P1T2=P2T1 but I was wondering what I would plug in as pressure and temp?

More Similar Questions