chemistry

posted by .

what would be the volume of 0.05 mole of carbon tetra chloride gas ccl4 ar rtp

  • chemistry -

    1 mole of a gas at STP has a volume of 22.4 L, so (0.05/1)*22.4L should give you the volume at STP.

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. AP chemistry

    If 25.0g of water are decomposed at RTP how would you find the volume of hydrogen gas produced?
  2. Chemistry

    Carbon tetrachloride CCl4 contains carbon (EN = 2.5) and chloride (EN = 3.0). Because of this, CCl4 is:
  3. chemistry

    at 700 k the equilibrium constant for the reactions is Kp=0.76. Carbon tertrachrolide gas yields carbon solid and chlorine gas. A flask is charged with 2.00 atm of CCl4, which then reaches equilibrium at 700K. A) what is the fraction …
  4. Chemistry

    A solution of iodine (I2) in carbon tetra-chloride(CCl4) is used when iodine is needed for certain chemical tests. how much iodine must be added to prepare a 0.480 m solution of iodine in CCl4 if 100.0g of carbon tetra-chloride is …
  5. Chemistry Urgent

    1) 30cm3 of methane and ethane mixed with 100cm3 of O2 at RTP. Explosion occurs, on cooling 61.5cm3 remained. Find the percentage by volume of each gas in the mixture 2)32cm3 of a mix of CO2, CH4 and H2 mix with 50cm3 of O2 and exploded …
  6. Chemistry

    Carbon tetracholoride is made according to the following reaction: carbon disulfide + chlorine gas yields carbon tetrachloride and disulfur dichloride. Write the correct balanced equation and then determine how many grams of CS2 are …
  7. science

    You burn 6 grams of carbon in plenty of air: C ( s) + O2 ( g) = CO2 ( g) a What volume of gas will form (at rtp)?
  8. science

    3 Nitroglycerine is used as an explosive. The equation for the explosion reaction is: 4C3H5(NO3)3 ( l ) 12CO2 ( g) 1 10H2O ( l ) 1 6N2 ( g) 1 O2 ( g) a How many moles does the equation show for: i nitroglycerine?
  9. Chemistry

    Ok so I realize this is a lot of questions, but if someone could at least just give me the general set up for each problem that would save my life! In each of the four problem in this section, all gases are measured at the same temperature …
  10. Chemistry

    I posted this before and I know now to use P1T2=P2T1 but I was wondering what I would plug in as pressure and temp?

More Similar Questions