Physics

posted by .

Assuming the fluid has a density of 1.00 (g/cm^) at what height h should the bottle be placed so the liquid pressure is 38mm-Hg ?

B.At what height h should the bottle be placed so the liquid pressure is 460mm-H_2O ?

C.If the blood pressure is 18 {mm-Hg} above atmospheric pressure, how high should the bottle be placed so that the fluid just barely enters the vein?

  • Physics -

    D(mercury)*P(mercury)=D(liquid)*h(liquid)

    a)13.5*38=1*h do rest like this to

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. Chemistry - Gas Laws

    Liquid helium at 4.2 K has a density of 0.147 g/mL. Suppose that a 1.00-L metal bottle that contains air at 118K and 1.0 atm pressure is sealed off. If we inject 120.0 mL of liquid helium and allow the entire system to warm to room …
  2. physics

    A hydraulic lift has two connected pistons with cross-sectional areas 5 cm2 and 350 cm2. It is filled with oil of density 740 kg/m3. a) What mass must be placed on the small piston to support a car of mass 1400 kg at equal fluid levels?
  3. physics

    A hydraulic lift has two connected pistons with cross-sectional areas 5 cm2 and 350 cm2. It is filled with oil of density 740 kg/m3. a) What mass must be placed on the small piston to support a car of mass 1400 kg at equal fluid levels?
  4. physics

    A patient is to be given a blood transfusion. The blood is to flow through a tube from a raised bottle to a needle inserted in the vein . The inside diameter of the 4.8 cm long needle is 0.48 mm, and the required flow rate is 4.9 cm^3 …
  5. Physics

    Intravenous infusions are often made under gravity. At what height should the bottle be placed so the liquid pressure is 700 mm-H2O?
  6. PHYSICS

    The pressure at the bottom of a vessel filled with liquid does not depend on: a- the acceleration of gravity b- the liquid density c- the height of the liquid d- the area of the liquid surface
  7. physics

    A glass bottle of soda is sealed with a screw cap. The absolute pressure of the carbon dioxide inside the bottle is 1.50 x 105 Pa. Assuming that the top and bottom surfaces of the cap each have an area of 4.20 x 10-4 m2, obtain the …
  8. Chemistry

    A 0.75–L bottle is cleaned, dried, and closed in a room where the air is 22oC and 44% relative humidity (that is, the water vapour in the air is 0.44 of the equilibrium vapour pressure at 22oC). The bottle is brought outside and …
  9. Chemical Engineering

    When a manometer is subjected to a time dependent pressure differential, the level of liquid in the legs changes with time according to the equation: (L/g)*(d^2h/dt^2)+(8uL/ygr^2)*(dh/dt)+h = dp/yg where L = length of liquid in tube, …
  10. Science

    In an experiment ti determine the density of a liquid the following pieces of information were obtained. Mass of empty bottle=50g Mass of bottle and liquid=85g Volume of liquid=100cm^3 Use the information to determine the density of …

More Similar Questions