Physics

posted by .

A 155 N force is applied to the end of a 40 cm wrench at a angle of 45 degrees to the handle. What is the torque?

  • Physics -

    155N cos45 *0.40 m = ___ N-m

  • Physics -

    43.84 N m

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. physics

    To tighten a bolt, you push with a force of 90 N at the end of a wrench handle that is 0.45 m from the axis of the bolt. (a) What torque are you exerting?
  2. Vectors

    A 50 N force is applied to the end of a 30 cm wrench and makes an angle of 30 degrees with the handle of the wrench. What is the Torque on the bolt at the other end of the wrench?
  3. physics

    To tighten a bolt, you push with a force of 72 N at the end of a wrench handle that is 0.26 m from the axis of the bolt.What torque are you exerting?
  4. physics- MC QUESTIONS

    Q 1: which of the following conditions occur when an object is in static equilibrium ?
  5. Physics

    A bolt requires 15 Nm or torque to loosen it. How much force needs to be applied to a 20 cm long wrench to loosen the bolt?
  6. Physics

    A force of 32 N is applied at the end of a wrench handle that is 27 cm long. The force is applied in a direction perpendicular to the handle as in the diagram. (a) What is the torque applied to the nut by the wrench?
  7. physics

    According to the manual of a certain car, a maximum torque of magnitude 76.0 N · m should be applied when tightening the lug nuts on the vehicle. If you use a wrench of length 0.276 m and you apply the force at the end of the wrench …
  8. physics

    A worker applies a torque to a nut with a wrench 0.485 m long. Because of the cramped space, she must exert a force upward at an angle of 57.0° with respect to a line from the nut through the end of the wrench. If the force she exerts …
  9. Physics

    A motorist is trying to loosen a stubborn lugnut by standing on the end of a wrench. The wrench is inclined 33.8 degrees above the horizontal and the distance from the center of the nut to the end of the wrench is 0.60 m. Assuming …
  10. vectors/work

    . In many applications a bolt is required to be tightened to a specific moment (torque), this is measured with a torque wrench. A bolt is located at the origin and is rotated so that the axis of rotation should be the z axis. A 0.5 …

More Similar Questions