Intergated chemistry/physics

posted by .

Draw a setup containing 3 gears. For every turn of the input gear, you need the output gear to spin 9 times. The drawing doesn't have to be perfect, but make sure to label the input gear, the output gear, and the number of teeth on each gear. Please E-mail me the picture at xlauralullabyx @ gmail. com

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. drive-ing problem

    hi this is my problem... A shaft turning at the 1800 r/min is coupled to a gear with 80 teeth, matching a gear with 62 teeth. In turn this gear is fitted to an intermediate shaft driving a gear with 40 teeth. This gear in turn drives …
  2. science

    A gear with 30 teeth turns a gear with 5 teeth. How many turns will the driven gear turn for every turn the drive gear makes?
  3. 9th grade science

    if the turns of the output gear over the turns of the input gear is equal to the number of teeth on the input gear over the number of teeth on the output gear, the input gear has 36 teeth and the output has 10, the output gear has …
  4. math

    i need help on ratios, gears and teeth.ex. teeth on driving gear A-35 teeth on driving gear B-?
  5. Math

    2 Gears are in their starting position. Gear 1 has 6 teeth. Gear 2 has 8 teeth. As gear 1 turns, it causes gear 2 to turn at a different rate. Gear 1 is rotated until the two gears are back at starting position. What is the minimum …
  6. MTH 156

    When two gears are mashed the revolution per minutes (rpm) are inversely proportional to the number of teeth, as show below. In one machine the rpm ratio of the larger gear to the small gear is 4:7 The small gear has 216 teeth In second …
  7. pre-calculus

    two gears are connected by a belt. the large gear has a radius of 20cm while the small gear has a radius of 10cm. if a point on the small gear travels at 16 rpm (revolutions per minute), find the angular velocity of the large gear. …
  8. Algebra

    Bambi is restoring a clock with a broken gear. A fragment of the small gear has 5 teeth . a larger unbroken gear has 18 teeth and is 2cm in dia.She knows that for every 2 times the large gear turns the smaller gear turns 3 times. How …
  9. Physics

    1) Design a gear system using 12, 34 and 36 teeth gears that achieve a gear ratio of 13.5:1 and has the top and bottom gear spinning in opposite directions. 2) For a pulley system with 8 supporting strands, how far would you have to …
  10. value

    if gear A has 3 teeth and drives gear B with 75teeth,how many times does gear A rotate for each rotation of B?

More Similar Questions