Chem Lab

posted by .

I did a chem lab and have to figure out some stuff off of some data I found during the lab

Weight of empty crucible and cover: 19.74 g
Weight of crucible, cover and hydrated salt: 22.74 g
Weight of crucible, cover and hydrated salt after 1st heating: 22.13 g
Weight of crucible, cover and hydrated salt after 2nd heating: 22.56 g
Weight of crucible, cover and hydrated salt after 3rd heating: 21.54 g


Calculate the weight of the hydrated salt.

Calculate the weight of the anhydrous salt.

  • Chem Lab -

    http://www.jiskha.com/display.cgi?id=1349747546

  • Chem Lab -

    Calculate the weight of the water lost by heating.

    Calculate the percentage of water in the hydrate.

    Calculate the number of moles of H2O lost by heating.

    Calculate the number of moles of anhydrous salt.

    Enter the formula of the hydrated salt.


    Calculate the theoretical percentage of the water in the hydrate.

    Calculate the experimental error.

    Calculate the percentage error.

  • Chem Lab -

    I need help with these problems as soon as posible Please

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. Lab in general

    I just read my syllabus for lab and I am kind of shocked at what it says. I do know that I have to write out procedures of the lab in my nbk before coming to lab but I just read that it says "You will NOT be allowed to refer to you …
  2. Chemistry

    A hydrated MgSO4 salt, weighing 3.211g, is heated in a crucible until reaching a constant weight. The weight of the anhydrous MgSO4 is 1.570 grams. 1. Calculate the moles of H20 removed and the moles of anhydrous MgSO4 remaining in …
  3. Chemistry

    Hello, I am having trouble with a question from my chem lab. Here is my data Weight of empty crucible and cover = 21.113 g Weight of crucible, cover, MgO and Mg3N2 = 21.906 g Weight of crucible, cover, MgOand addition of H2O and heat …
  4. Chemistry

    A student recorded the following data for copper sulfate pentahydrate. Weight of crucible and cover (after heating to constant weight), 28.120g Weight of covered crucible plus sample, 31.020g Weight of covered crucible plus sample …
  5. chem 121

    We did a lab separating out the components of a mixture. One of the lab questions is "The weight of naphthalene was obtained by weighing the collected solid. Was this an accurate weight of the naphthalene present in the original sample?
  6. Chem Lab

    I did a chem lab and have to figure out some stuff off of some data I found during the lab Weight of empty crucible and cover: 19.74 g Weight of crucible, cover and hydrated salt: 22.74 g Weight of crucible, cover and hydrated salt …
  7. Chemistry

    Weight of empty crucible and cover = 23.104 g Weight of crucible, cover, MgO and Mg3N2 = 24.199 g Weight of crucible, cover, MgOand addition of H2O and heat = 24.290 Calculate the number of moles of Mg3N2.
  8. Chemistry Lab

    In chemistry we are doing a lab that involves crucibles and Mg ribbon, we have three days to complete the lab. Anyways do you think it would be alright to substitute the mass of the crucible we had the first day with the mass of the …
  9. CHEMISTRY

    is this right? 5. After heating the crucible is set on the lab bench where it is contaminated with the cleaning oil used to clean the lab bench but before its mass is measured. The analysis continues where the mass of the anhydrous
  10. Coordinated Sciences (chem)

    Hi guys, so we recently did a lab where we put a strip of Magnesium Carbonate in a crucible with a lid on, weighed it and then put it over a bunsen burner for a while to let it oxidise. After that, we weighed it again. Here are my …

More Similar Questions