chemistry

posted by .

How are the spots on the TLC plates observed?

  • chemistry -

    1. visually
    2. with fluorescence
    3. spray with dye, then visual
    4. other.

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. Sample purity

    Question: A student spots an unknown sample on a TLC plate and develops it in pentane solvent. Only one spot, for which the Rf value is 0.05, is observed. Is the unknown a pure compound?
  2. science(chemistry)

    I have a question about TLC plate solvents. What solvents will leave stains on a plate with a TLC plate out of the ones below and why?
  3. Chemistry

    You and another student were each given an unknown compound. Both samples contained colorless material. You each used the same brand of commercially prepared TLC plate and developed the plates using the same solvent. Each of you obtained …
  4. Chemistry

    Assume your sample spots are 1 cm above the bottom of the TLC plate. What happens if you put the plate in a developing chamber that has 1.2 cm of developing solvent?
  5. Organic Chemistry

    Thin Layer chromatography TLC experiment What does it mean when it says with to much sample the spots will tail
  6. Chemistry!!!

    1.)The silica that makes up the stationary phase in TLC chromatophraphy is more polar than the mobile phase. What then might the relative positions of the analgesics on the developed TLC plate tell you about the polarity of these molecules?
  7. Chem---DrBob222

    -----Chromatograph----- Carrying out TLC on colorless compounds. Give two examples of methods to use in order to visualize the spots on the plates. Carrying out TLC with a mixture of two compounds A and B. A is less polar than B. on …
  8. Organic Chemistry

    I spotted a commercial TLC plate, coated with silica gel, with a pure benzoin solution. After running the TLC plate in methylene chloride, the benzoin separated into two different spots. Rf values are 0.6 and 0.9. What explains this?
  9. Chemistry

    A three component mixture was run on tlc. When the solvent front migrated 20 cm the spots representing the components appeared at 5 cm, 10 cm, and 15 cm. What are the Rf values of the three components.
  10. Chemistry

    You carry out tlc on silica gel of a mixture of compound A and B. Using a mobile phase of hexane 50% and acetone 50% the Rf values of were A 0.15, B 0.2, and the spots were overlapping. What change would you make to the solvent composition …

More Similar Questions