chemistry

posted by .

In hard water analysis, the end point is reached when 13.5 mL of 0.0913 M standardized EDTA has been added. Determine the water hardness in equivalence of CaCO3. That is, determine the mg CaCO3 per liter

  • chemistry -

    13.5 mL x 0.0913M = millimoles EDTA = millimoles CaCO3.
    g CaCO3 = mols x molar mass CaCO3.

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. Analytical Chemistry

    Predict the effect (Increase, Decrease, No effect, Indeterminate)and explain why 1. Condition: In the determination of water hardness, the water sample contained appreciable amount of ferric ions Paameter: ppm CaCO3 2. Condition: Instead …
  2. chemistry

    Predict the effect (Increase, Decrease, No effect, Indeterminate)and explain why 1. Condition: In the determination of water hardness, the water sample contained appreciable amount of ferric ions Paameter: ppm CaCO3 2. Condition: Instead …
  3. analytical chemistry

    Predict the effect (Increase, Decrease, No effect, Indeterminate)and explain why 1. Condition: In the determination of water hardness, the water sample contained appreciable amount of ferric ions Paameter: ppm CaCO3 2. Condition: Instead …
  4. chemistry

    Hi. We did an experiment on Quantitatve Determintion of Total Hardness in Drinking water by Complexometric EDTA Titration and I have a lot of questions. 1. What is the concept of complexometric titration and water hardness?
  5. chemistry

    A 100.0 mL sample of hard water is titrated with the EDTA solution from Part 2. The same amount of Mg2+ is added as previously, and the volume of EDTA required is 22.44 mL What volume of EDTA is used in titrating the Ca2+ in the hard …
  6. Chemistry

    For water hardness experiment using EDTA titrant: 1. Suppose water hardness was 600mg CaCO3/L, how much sample should be used to ensure 10-50mL of titrant will be used (assuming titer of 1.00mg CaCO3/ml EDTA) 2. How can EDTA be used …
  7. CHEM AB HELP ASAP

    I have a pre lab questions that are due in a few hours and I need help. Theres several questions In the titration of 25.00 ml of a water sample, it took 20.590 ml of 4.995x10-3 M EDTA solution to reach the endpoint. The total hardness …
  8. analytical chemistry

    In an experiment for determining water hardness, 75.00 ml of a water sample required 13.03 ml of an EDTA solution that is 0.009242 M. What is the ppm CaCO3 in this sample?
  9. chemistry

    25 ml of SHW containing CaCO3 1 g/L consumes 12 ml of EDTA. 25 ml of hard water consumes 8 ml of standard EDTA solution. After boiling the sample, 25 ml of the boiled hard water consumes 6 ml of standard EDTA solution. Calculate the …
  10. Chemistry

    Hardness is defined as calcium and magnesium ion content. Since most hardness is caused by carbonate mineral deposits and does not distinguish calcium and magnesium ions, hardness is usually reported as parts per million (ppm) of calcium …

More Similar Questions