Chemistry

posted by .

An air bubble is present in the stopcock at the start of the titration but is passed out during the titration. Would this error make your calculated molarity of zinc ions higher or lower than the true value?

Thanks!

  • Chemistry -

    I have no idea what you talking about BUT the volume of the buret will read too high so what effect will that have?

  • Chemistry -

    Ok, I got it, thanks Dr. Bob.

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. Chem+ASAP+2 fill in the blank questions+ASAP!!!

    PLease check this. They are fill in the blank and I just need to know if they are right. Thanks! 9. Compared to a strong acid-strong base titration curve, a weak acid-strong base titration curve has a (higher, lower) __higher___ initial …
  2. chemistry

    When filling the buret with NaOH solution, you left an air bubble in the buret tip. The bubble was released durning your first KHP titration. Would the following technique error result in an erroneously high or reeoneously low calculated …
  3. science-chem- theory questions

    please, help me.. i think i know the answers, but i just want to make sure! i'd love your feed back :) 1) an air bubble is trapped in the tip of a buret before a titration. during the titration, the bubble is passed from the buret …
  4. chemistry

    if air bubbles remain in the burette during the titration, what will the effect be on the calculated values of :: a- the concentration of NaOh b- the molarity of H2SO4 ?
  5. CHEMISTRY II

    How would the calculated value of the molar mass of an unknown acid be affected (higher, lower, or no change) if the following occurs?
  6. Chemistry

    If two titrations were completed were completed: 1) the titration of HCl with Na(OH) 2)the titration of HCl with Ba(OH)2 (the concentrations of acid and base for both titrations are the same) How would the titration curves of each …
  7. Chemistry

    I don't know how to reply to an answer. First of all thank you! For the question I just asked about the titration curves. Would that mean that titrating with barium hydroxide would take half the volume that is used when titrating with …
  8. Chemistry

    At the beginning of a titration to standardize the NaOH solution, Student A adjusted very carefully the initial burette volume to 0.00 mL, but he did not notice an important air bubble in the tip of the burette. At the end of the titration, …
  9. Chemistry

    The bubble in the tip of the buret is not removed prior to performing the NaOH standardization. Will the reported concentration of the NaOH be greater than, less than, or equal to the true concentration of the NaOH if the bubble is …
  10. Chemistry

    How would the following affect the calculated value of neutralizing power of antacid (make it higher, lower or no effect)?

More Similar Questions