Chemistry

posted by .

Explain how the calculated molarity of the potassium permanganate would be affected by each of the following experimental errors. In each case, you must also state if the calculated molarity is higher or lower than the actual morality.
a) Some sodium oxalate was spilled after it had been weighed out on the analytical balance.

b) Prior to its use, the pipet has not been rinsed with the standard sodium oxalate solution.

c) The Erlenmeyer flask was rinsed with the sodium oxalate instead of deionized water before the 25.00 mL solution was measured into it.

d) The endpoints were repeatedly overshot.

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. acid-base titrations

    For each of the following circumstances, indicate whether the calculated molarity of NaOH would be lower, higher or unaffected. Explain your answer in each case. a.the inside of the pipet used to transfer the standard HCI solution …
  2. AP Chemistry

    So i had trouble finding the answers to these questions on a lab: Background: If we were using a burret/flask instead of a pipette and well plates. Before you started, the buret must be rinsed with 1 ml of distilled water and then …
  3. Chemistry

    Using Volumetric Glassware to Measure, Dilute,and Titrate Acid Solution 1)For each of the following procedural errors, indicate whether the calculated molarity of the HCl solution would be higher or lower than the actual molarity. …
  4. Chemistry

    Explain how the calculated molarity of the potassium permanganate would be affected by each of the following experimental errors. In each case, you must also state if the calculated molarity is higher or lower than the actual morality. …
  5. Chemistry

    An air bubble is present in the stopcock at the start of the titration but is passed out during the titration. Would this error make your calculated molarity of zinc ions higher or lower than the true value?
  6. CHEMISTRY II

    How would the calculated value of the molar mass of an unknown acid be affected (higher, lower, or no change) if the following occurs?
  7. Chemistry

    I am not sure if I calculated the exact molarity of the potassium permanganate. I multiplied the molarity of the potassium permanganate by the liters of potassium permanganate used in the titration and divided it by the total liters …
  8. Chemistry

    I am not sure if I calculated the exact molarity of the potassium permanganate. I multiplied the molarity of the potassium permanganate by the liters of potassium permanganate used in the titration and divided it by the total liters …
  9. Chemistry

    How will overshooting the end point of an acid-base titration by adding too much base to KHP affect the calculated molarity of the base?
  10. Chemistry

    At the beginning of a titration to standardize the NaOH solution, Student A adjusted very carefully the initial burette volume to 0.00 mL, but he did not notice an important air bubble in the tip of the burette. At the end of the titration, …

More Similar Questions