solid mechanics 1

posted by .

a load p is supported by a steel pin that has been inserted in a short wooden member hanging from the ceiling. the ultimate strength of the wood used is 60 MPa in tension and 7.5 MPa in shear, while the ultimate strength of the steel is 145 MPa in shear. knowing that b= 40 mm, c= 55mm, and d=12mm, determine the load P if an overall factor of safety of 3.2 is desired. [ans : 10.25 ]

  • solid mechanics 1 -

    To answer your question, I would need to see the figure that defines b, c and d, and explains how the pin is supported by the wood.

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. Statistics

    The fracture strength of a certain type of manufactured glass is normally distributed with a mean of 579 MPa with a standard deviation of 14 MPa. (a) What is the probability that a randomly chosen sample of glass will break at less …
  2. Mechanics

    A tension test was performed on a steel specimen having an original diameter of 12.5 mm and gauge length of 50 mm. Using the data listed in the table, plot the stress–strain diagram, and determine approximately the modulus of toughness. …
  3. Statistics

    The fracture strength of a certain type of manufactured glass is normally distributed with a mean of 579 MPa with a standard deviation of 14 MPa. (a) What is the probability that a randomly chosen sample of glass will break at less …
  4. statistics

    1. The fracture strength of a certain type of manufactured glass is normally distributed with a mean of 579 MPa with a standard deviation of 14 MPa. (a) What is the probability that a randomly chosen sample of glass will break at less …
  5. Physics

    What is the factor of safety of a steel hanger having an ultimate strength of 630.000MPa and supporting a load of 65000.000N. The steel hanger in question has a cross sectional area of 5.300cm. ANS = (Round to 3 decimal places) Load …
  6. Physics

    What is the factor of safety of a steel hanger having an ultimate strength of 630.000MPa and supporting a load of 65000.000N. The steel hanger in question has a cross sectional area of 5.300cm. ANS = (Round to 3 decimal places) Load …
  7. Physics

    What is the factor of safety of a steel hanger having an ultimate strength of 630.000MPa and supporting a load of 65000.000N. The steel hanger in question has a cross sectional area of 5.300cm. ANS = (Round to 3 decimal places) Load …
  8. Physics Classical Mechanics

    A long rod hangs straight down from one end. How long (in meters) can the rod be before its weight causes it to break off at the end if it is made of iron?
  9. solid mechanics

    A steel plate is subjected to tensile stresses of 200MPa and 150 MPa at right angles to each other. Determine the normal and tangential stresses on a plane inclined at 60 to the 200 MPa stress. Also find the plane on which the resultant …
  10. Physics

    For chlorine gas, the van der Waals constants are: a = 0.658 J·m3/mol2, and b = 5.62 × 10-5 m3/mol. A 3.0-L tank contains 10.0 moles of chlorine gas at a temperature of 625 K. What is the pressure in the container?

More Similar Questions