Post a New Question

math(trig)

posted by .

1) What's the linear velocity of a point on the tip of a 6-ft propeller turning at 1200 revolutions per min?

2) A gear is driven by a chain that travels 90m/min. Find the radius of the gear if it makes 50 revolutions per minute.

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. drive-ing problem

    hi this is my problem... A shaft turning at the 1800 r/min is coupled to a gear with 80 teeth, matching a gear with 62 teeth. In turn this gear is fitted to an intermediate shaft driving a gear with 40 teeth. This gear in turn drives …
  2. science

    A gear with 30 teeth turns a gear with 5 teeth. How many turns will the driven gear turn for every turn the drive gear makes?
  3. math(trig)

    1) A 6-ft propeller turns at 1200 revolutions per minute. Compare the angular velocity of the tip with the angular velocity at a point 10 in. from its center. 2) What is the angular velocity of a point on the tread of a 15-in. diameter …
  4. physics

    Two gears A and B are in contact. The radius of gear A is twice that of gear B. (a) when A’s angular velocity 6.00 Hz counter clockwise, what is B’s angular velocity?
  5. physics

    If an airplane propeller rotates at 1570 rev/min while the airplane flies at a speed of 333 km/h relative to the ground, what is the linear speed of a point on the tip of the propeller, at radius 1.97 m, as seen by (a) the pilot and …
  6. math

    A gear with 60 teeth is meshed to a gear with 40 teeth. If the larger gear revolves at 20 revolutions per minute, how many revolutions does the smaller gear make in a minute?
  7. math help

    A gear with 20 teeth revolving at 200 revolutions per minute is meshed with a second gear turning at 250 revolutions per minute. How many teeth does this gear have ?
  8. trig

    A gear with a radius of 32 centimeters is turning at pi/9 radians/sec. What is the linear speed (velocity) at a point on the outer edge of the gear?
  9. pre-calculus

    two gears are connected by a belt. the large gear has a radius of 20cm while the small gear has a radius of 10cm. if a point on the small gear travels at 16 rpm (revolutions per minute), find the angular velocity of the large gear. …
  10. math

    the speed of a gear wheel varies inversely as the number of teeth of the gear. if a gear wheel which has 48 teeth makes 3 revolutions per minute. how many revolutions per minute will a gear wheel with 96 teeth make?

More Similar Questions

Post a New Question