Physics

posted by .

draw a ciruit of 2 lamps in parllel with each other connected to a power source and an ammeter to measure the total current of the circuit and a voltmeter to measure the potential difference across the two lamps

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. Physics

    1)A 2.0-V battery is connected in a circuit with an ammeter and an unknown resistor, P. The current is observed to be 0.70 A. What would be the current in the circuit if a 12-V battery replaces the 2.0-V battery?
  2. Physics

    A circuit contains sic 60-W lamps with a resistance of 240-ohm each and a 10.0-ohm heater connected in parallel. The voltage across the circuit is 120 V. Find the current in the circuit for the following situations:::: a. four lamps …
  3. Physics

    A circuit contains sic 60-W lamps with a resistance of 240-ohm each and a 10.0-ohm heater connected in parallel. The voltage across the circuit is 120 V. Find the current in the circuit for the following situations:::: a. four lamps …
  4. Physics

    The battery in the circuit diagram has an EMF of 12V and an unknown internal resistance r. Voltmeter V1 is connected across the battery and voltmeter V2 is connected across the switch S. The resistance of the connecting wires and the …
  5. Physics

    The battery in the circuit diagram has an EMF of 12V and an unknown internal resistance r. Voltmeter V1 is connected across the battery and voltmeter V2 is connected across the switch S. The resistance of the connecting wires and the …
  6. engineering science

    The power in a resistor RLOAD of 10 Ω when connected to a 100 volt supply is measured using a voltmeter and ammeter. There are two possible ways of connecting the meters as shown in FIGURE 2. The resistances RA and RV represent …
  7. Physics

    A circuit contains six 270 lamps and a 18.0 heater connected in parallel. The voltage across the circuit is 120 V. (a) What is the current in the circuit when four lamps are turned on?
  8. Algebra

    Two lamps can be connected to a battery in a circuit in series or in parallel. You can calculate the total resistance RT (t is down from r) in a circuit if you know the resistance in each lamp. Resistance is measured in ohms. For a …
  9. Algebra

    Two lamps can be connected to a battery in a circuit in series or in parallel. You can calculate the total resistance RT (t is down from r) in a circuit if you know the resistance in each lamp. Resistance is measured in ohms. For a …
  10. physics

    A hose contains 20 lamps of 200 W for each lamp and a heater of power 1500 W. they are all connected to supply voltage of 240 volt. Calculate; (a) The total current when all loads operates at the same time. (b) Total energy when 10 …

More Similar Questions