Chemistry

posted by .

For how long should you boil the water in the flask during your experiment?

  • Chemistry -

    For what experiment?

  • Chemistry -

    Determining the Molar Mass of a Volatile Liquid

  • Chemistry -

    Follow the instructions.

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. Chemistry

    A stock solution was prepared by dissolving exactly 0.4000 g of pure ASA (180.16g/mol) in 10.00 mL of NaOH and heating the solution to a gentle boil. After cooling to room temperature, the solution was poured into a 250 ml volumetric …
  2. physics

    A physicist, upon awaking one morning to find his stove out of order, decides to boil the water for his wife's coffee by shaking it in a thermos flask. Suppose that he uses 520 cm3 of tap water at 56oF, that the water falls 1.35 ft …
  3. chemistry

    Mass of Aspirin tablet: 0.357 g 10 mL of 1 M NaOH was added to the aspirin tablet in a 125 mL Erlenmeyer flask and heated to a boil. The solution was transferred to a 100 mL volumetric flask and the flask was filled to the mark with …
  4. Chemistry!

    A sealed flask contains 0.60 g of water at 28 degrees celcius. The vapor pressure of water at this temperature is 28.36 mmHg. What is the minimum volume of the flask in order that no liquid water be present in the flask?
  5. Chemistry

    during a molar volume of oxygen experiment indicate how each of the following errors would affect (increase, decrease, or no change) your calculated value for the molar volume of O2 at STP. 1.) Your sample was not completely decomposed. …
  6. Chemistry

    during a molar volume of oxygen experiment indicate how each of the following errors would affect (increase, decrease, or no change) your calculated value for the molar volume of O2 at STP. 1.) Your sample was not completely decomposed. …
  7. chemistry

    A student obtained a clean, dry, glass stoppered flask. The weight of the flask and stopper was 32.634 g. The student filled the flask with water and obtained a mass for the full stoppered flask of 59.479 g. The density of water at …
  8. Chemistry

    In a similar experiment, a student needs a 0.50 M KOH solution (MM = 56.11 g/mol). The student only has a 50.00 mL volumetric flask. How much KOH should be added before the flask is filled with water?
  9. chemistry

    An alka-seltzer tablet weighing 3 grams is added to a flask of water (weighing 250 grams).At the end of the experiment, the flask weighs a total of 249.6 grams.Explain why this experiment does not seem to follow the Law of Conservation …
  10. Chemistry

    Can you check my answers? Thanks!!!! What would happen to the volume-to-temperature ratio if: 1. One student failed to replenish the boiling water in the boiling-water bath as the flask was being heated. At the end of the 6 min of

More Similar Questions