Questions LLC
Login
or
Sign Up
Ask a New Question
Circuit Analysis
Page 2
Questions (131)
I need help solving this circuit. I don't know where to start in regards to finding the total resistance. Is r4 in series with
1 answer
asked by
Mike
369 views
Given the circuit below with unknown voltage source and a voltage drop of 2.233 v Volts on resistor R3, with (R1 = 2KΩ, R2 =
3 answers
asked by
Mike
466 views
The question is to determine the range for Vs in which both diodes are on:
--------R1-------+D1- ---------------- -D2+ -------- |
1 answer
asked by
EE student
373 views
hevenin resistance Rth is found [ ]
(A) by removing voltage sources and replace with their internal resistances (B) by
2 answers
asked by
dumon
479 views
Suppose we have a circuit where the ratio of the complex amplitude of the particular integral to the amplitude of the driving
1 answer
asked by
sengeni
374 views
A circuit with a single 25.0 omega resistor runs for 5.00 s. During this time10.0 C pass through a point in the circuit.
a. What
1 answer
asked by
elaine
473 views
_____R____________
| | | |+ | XC E1 XL | |- | |+ | | E2 ___________________- Z1 = R= 4 ohms <0 4+-j0 Z2 = XL= 6 ohms <90. 0+j6 Z3
4 answers
asked by
TJ
398 views
#10 (5 points possible)
At what frequency in Hz will this circuit have the same current with the switches open and with the
1 answer
asked by
JuanPro
414 views
Two resistors 3ohms and 6ohms are connected in parallel across a 6V battery, what is the current flow through the 3ohms
5 answers
asked by
Tyler
517 views
The step response of a circuit is its response to a step input, u(t). Knowing the step response of a linear circuit is extremely
6 answers
asked by
sushma
705 views
A tunable capacitor (with variable capacitance) is charged by a U
0=12 V battery and then is connected in parallel to a R=3 Ω
2 answers
asked by
andrew
504 views
A parallel RL circuit has a reactance of 250 W and a resistance of 125 W. The phase angle of the circuit impedance is
3 answers
asked by
Adam
321 views
A tank circuit in a radio transmitter is a series RCL circuit connected to an antenna. The antenna broadcasts radio signals at
1 answer
asked by
anonymous
853 views
I'll try to explain the schmatic drawing...
a 120V battery, total of 12A, leads into a 8ohm resistor (R1), then breaks off into
7 answers
asked by
Dav e
451 views
What is the upper tripper point (UTP) of a comparator with hysteresis if R1 = 47 kÙ, R2 = 68 kÙ and the maximum positive
1 answer
asked by
Robbie
301 views
1. A 26.0-Ω resistor, a 12.0-µF capacitor, and a 17.0-mH inductor are connected in series with a 150-V generator.
(a) At what
2 answers
asked by
linds
641 views
measure resistance with a multimeter in a circuit is the power going to be off or on
i think ON
1 answer
asked by
LISA
389 views
measure resistance with a multimeter in a circuit is the power going to be off or on
i think ON
1 answer
asked by
LISA
337 views
a parallel combination of two resistors of 2ohm each has third resistor of 4ohm in series with the combination.if a battery of
3 answers
asked by
brock
452 views
discuss your thoughts on the use of thevenin equivalent circuit.
2 answers
asked by
Dan
777 views
Three cells are connected as shown. The internal resistance of each cell is 2 ohms. The voltage of each cell is 1.5 volts. The
3 answers
asked anonymously
53 views
what is the total resistance in a circuit having 3 feetof 10 ohm/ft wire, with two 15 ohm resistors wired in parallel?
2 answers
asked by
tom
1,166 views
Internal resistance problem.
Suppose that in Figure 3.3, Vo=13V, R1=250kphm, R2=375kohm, and Ri=1.9Mohm. Initially, the voltmeter
1 answer
asked by
james
776 views
When switch S in the figure is open, the voltmeter V of the battery reads 3.13V . When the switch is closed, the voltmeter
2 answers
asked by
Lanise
1,252 views
to which side of the source is the position terimnal danammeter conected to when it is placed into circurit
1 answer
asked by
john
312 views
For any reference or data value unless otherwise mentioned, Explorer 16 board will be used as default. Show all your work for
3 answers
asked anonymously
33 views
A source with 50 ohm source impedance drives a 50 ohm T-line that is 1/8 of a wavelength long, terminated in a load Z=50-j25
2 answers
asked by
Anonymous
557 views
How much current flows in a 12-watt radio connected to a 120-Volt circuit?
1 answer
asked by
Jordan
389 views
which of the following statements is a true statement concerning the T-N theorem? #1-the T-N theorem can be applied only to d-c
5 answers
asked by
dale mckinney
470 views
If we Thevenize the Norton equivalent of a circuit,the result will be the Thevenin equivalent of the original network. True or
1 answer
asked by
dale mckinney
431 views
We had to do a RC Circuit experiment in the lab one step in the procedure goes as follows:
Record the time needed to discharge a
1 answer
asked by
Damon
502 views
Look at the circuit diagram.
How many switches does the diagram show? one two three four
11 answers
asked by
RedClover13
55 views
A 2.0-ohm resistor is connected in series with a 20.0-V battery and a three-branch parallel network with branches whose
3 answers
asked by
leo
1,390 views
A circuit consists of a 10 ohm resistor in series with 3 identical batteries each with an emf = 1.0V and internal resistance of
3 answers
asked by
Joe
1,186 views
Complete the table and show all your calculations. Determine the power of the circuit.
Circuit Diagram: -- A -- V -- | -- R1 --
4 answers
asked anonymously
43 views
11. If you have a circuit set up where you have have a 9 V battery and one resistor of 10 Ohms. You place a voltmeter across the
4 answers
asked by
H
1,071 views
In a circuit with a 10 ohm resistor in series with a 15 ohm resistor, total resistance is ________ ohms.
2 answers
asked by
josue
1,039 views
1)A 2.0-V battery is connected in a circuit with an ammeter and an unknown resistor, P. The current is observed to be 0.70 A.
6 answers
asked by
Jon
1,068 views
In a parallel circuit, ET = 240 V, R = 400 W, and XL = 300 W. What is P?
2 answers
asked by
sam
872 views
Consider the circuit shown in the figure below. (Assume R1 = 12.0 Ω and R2 = 6.00 Ω.)
Read this for the figure - A rectangular
1 answer
asked by
Div
875 views
For any reference or data value unless otherwise mentioned, Explorer 16 board will be used as default. Show all your work for
3 answers
asked anonymously
45 views
A 15.0 resistor and a 20.0 resistor are connected in parallel. A 5.00 resistor is connected across a 1.00 10^2-V battery. What
3 answers
asked by
sophie
791 views
6v battery of internal resistance 0.5 ohm connected to there resistors of values 3 ohm, 4 ohm, 5 ohm.
Calculate the current in
2 answers
asked by
Koffi
693 views
The voltage (V) applied to a 0.25 F capacitor is given by the equation :
v= (t^2-2t)^3/5t Find the current at t = 3.7 s. (i=C
2 answers
asked by
Preet
665 views
The rms output in a circuit is 7.75 A. What is the maximum current?
3 answers
asked by
Anonymous
597 views
A 19.0 ohm, 9.00 ohm , and 8.00 ohm resistor are connected in parallel to an emf source. A current of 9.00 A is in the 9.00
2 answers
asked by
Anonymous
614 views
1. Which circuit would be better to use for a Christmas tree lights and why?
2. Why does the lightbulb in the right electrical
2 answers
asked by
Khaliyl
589 views
Determine the maximum voltage drop across the resistor in the circuit.
s.yimg.com/tr/i/10ad923b2d124cbc9a6df99028e9a1b3_A.png
2 answers
asked by
AAA
592 views
This problem explores the difference between solving a circuit using the KCL/KVL method and the node method. The circuit shown
2 answers
asked by
juanpro
591 views
Batteries are not perfect. Instead they have an "internal resistance, a catch all phrase which describes the internal chemical
2 answers
asked by
raks
574 views
Pages
1
2
3
Parent Categories (17)
Circuit Configuration
Circuits
Electric Circuits
Electrical Circuits
Electrical Engineering
Electricity
Electricity and Circuitry
Electricity and Circuits
Electricity and Magnetism
Electronics
Energy
Graph Theory
Physics
Physics and Electronics
Physics/Electronics
Resistors
RL Series Circuit