Question:
A square garden has the end points listed below. Plot and label these points on the grid
Answer Choices:
* A ( -7, 6 )
* B ( -2, -6 )
* C ( 10, -1 )
* D ( 5, 11 )
It goes from 1 to 12 and -1 to -12
Unfortunately, without the specific points or dimensions of the square garden, it is not possible to accurately plot and label the points on the grid.
Both Point X and Point Y are on both ends of a right triangle of 12
If Point X is at one end of the right triangle with coordinates (12, a) and Point Y is at the other end with coordinates (12, b), then the points can be plotted on the grid.
The coordinates would be:
Point X: (12, a)
Point Y: (12, b)
Note: The y-coordinate of Point X can be any value in the range from -12 to 12, since it is not specified. Similarly, the y-coordinate of Point Y can also be any value in the range from -12 to 12.
But out of the answer choices?
Apologies for the confusion. Without the specific dimensions or additional information about the square garden, it is not possible to determine which answer choice corresponds to the given points.
To plot and label the points on the grid, we need to use the given coordinates. Each coordinate has two parts: an x-coordinate and a y-coordinate. The x-coordinate represents the position on the horizontal axis, while the y-coordinate represents the position on the vertical axis.
In this case, we have four points: A, B, C, and D. Let's plot and label them one by one:
A ( -7, 6 ):
Start by finding the x-coordinate -7 on the horizontal axis. Then, move up 6 units on the positive y-axis to locate the point. Mark this point as A (-7, 6).
B ( -2, -6 ):
Locate the x-coordinate -2 on the horizontal axis. Then, move down 6 units on the negative y-axis to locate the point. Mark this point as B (-2, -6).
C ( 10, -1 ):
Find the x-coordinate 10 on the horizontal axis. Then, move down 1 unit on the negative y-axis to locate the point. Mark this point as C (10, -1).
D ( 5, 11 ):
Locate the x-coordinate 5 on the horizontal axis. Then, move up 11 units on the positive y-axis to locate the point. Mark this point as D (5, 11).
After following these steps, you should have all the points plotted and labeled correctly on the grid. Double-check your work to ensure accuracy.