Questions LLC
Login
or
Sign Up
Ask a New Question
Electronics
Microcontrollers
Timer Modules
TIM7 is used to generate time base interrupts to implement the DDS clock frequency of 100 kHz. Determine the values of TIM7 ARR and PSC registers
if TIM7 clock is 80 MHz.
1 answer
ARR = 800
PSC = 79
You can
ask a new question
or
answer this question
.
Related Questions
My clock has gone wrong and chimes three times at one o'clock, four times at two o'clock, and so on. It also half-an-hour fast.
Neela's clock is broken the minute hand rotates around the clock correctly but the hour hand is stuck in the three o'clock
A certain slow clock loses 15 mins every hour. Suppose the clock is set to the correct time at 9 AM. What will the correct time
Hello!
Thanks for checking my question out! ____ Mia’s clock radio communicates the time, plays the radio, and sounds the alarm
A clock loses 10 minutes each day. How many days will it take to reach a point where the clock will indicate the right time?
A clock was set on Monday at 8.30 a.m. On Tuesday, the following day, the clock showed 8.45 p.m. when the correct time was 8.30
On Friday morning two clocks are correctly set at 6 a.m. One clock gains 1 minute every 2 hours. The other clock loses 1 minute
Determine the values of timer TIM7 prescaler (PSC) and autoreload (ARR) registers so set timer overflow period to 100 ms, if
An analog signal is sampled by 12-bit ADC triggered by timer TIM7. The timer clock frequency is 80 MHz. The value of TIM7_PSC
The following signal is sampled by 12-bit ADC triggered by timer TIM7. The timer clock frequency is 80 MHz. The value of
