college algebra

A circular vent pipe with a diameter of 5.5 inches is place on a roof that has a slope of 1/4.

Find an equation of the ellipse that should be cut from the roof so that the pipe will fit. roound parameters to the nearest hundreth.

  1. 👍 0
  2. 👎 0
  3. 👁 114

Respond to this Question

First Name

Your Response

Similar Questions

  1. Physics

    Please someone help..A horizontal pipe 10.0cm in diameter has a smooth reduction to a pipe 5.0cm in diameter. If the pressure of the water in the large pipe is 80000Pa and the pressure in the small pipe is 60000Pa at what rate

  2. physics

    Water moves through a constricted pipe in steady, ideal flow. At the lower point shown in figure below, the pressure is P1 = 1.75X104 Pa and the pipe diameter is 6.00 cm. At another point y = 0.250 m higher, the pressure is P2 =

  3. Math

    For any circle, which ratio is equal to the number π? Select all that apply. ***A. Circumference ------------------- Diameter B. Circumference ------------------- Radius ***C. Circumference ------------------- 2 Times Radius D.

  4. Math

    If the outer diameter of a metal pipe is 2.84 inches and the inner diameter is 1.94 inches, the thickness of the metal is A. 0.45 of an inch B. 0.90 of an inch C. 1.94 inches D. 2.39 inches

  1. Physics

    Water flows into one end of a horizontal, cylindrical pipe at 2.0 m/s. The pipe then narrows until its diameter at the opposite end is only 1/3 of that at the beginning. (a) What is the flow speed at the narrow end of the pipe?

  2. maths

    To fill a swimming pool two pipes are to be used.If the pipe of larger diameter I'd used for 4 hours and the pipe of smaller diameter for 9 hours only half the pool can be filled .Find ,how long it would take for each pipe to fill

  3. Math

    Renae needs to put trim around a circular tablecloth with a diameter of 36 inches. Use the equation C=PId to find three sets of approximations for the amount of trim she will need. Truncate the value of PI to the to the ones,tens,

  4. Fluid Mechanics

    Water flows into a cylindrical tank through pipe 1 at a rate of 25 ft/s and leaves through pipe 2 at 10 ft/s and through pipe 3 at 12 ft/s. Pipe 4 is an open air vent. Internal diameters of the pipes are: D1=3 in, D2= 2 in, D3=2.5

  1. Fluid Mechanics

    Oil (sp. gr.= 0.8) flows smoothly through the circular reducing section shown at 3 ft^3/s. If the entering and leaving velocity profiles are uniform, estimate the force which must be applied to the reducer to hold it in place.

  2. Physics

    A horizontal water pipe goes from a large diameter to a small diameter and then back to the first diameter as shown in the figure below. The level of water (8cm in the larger tube and 4 cm in the constricted tube) in the small

  3. Physics

    For an ideal fluid flowing through a horizontal pipe, Bernoulli's principle and the continuity equation state that the pressure within the pipe does which of the following? Pressure descreased pipe diameter increase?

  4. Fluid Mechanics

    Oil (sp. gr.= 0.8) flows smoothly through the circular reducing section shown at 3 ft^3/s. If the entering and leaving velocity profiles are uniform, estimate the force which must be applied to the reducer to hold it in place.

You can view more similar questions or ask a new question.