# Physics(Help!!!!!!)

A stick of length l = 65.0 cm rests against a wall. The coefficient of static friction between stick and the wall and between the stick and the floor are equal. The stick will slip off the wall if placed at an angle greater than Î¸ = 39.0 degrees. What is the coefficient of static friction, Î¼s, between the stick and the wall and floor?

Î¼s=

1. 👍 0
2. 👎 0
3. 👁 239
1. tan (theta)= (2*u_s)/(1-u_s^2)

,solve for u_s

1. 👍 0
2. 👎 0

## Similar Questions

1. ### Physics

A box rests on a rough board 10.0meters long. When one end of the board is slowly raised to a height of 6.0meters above the other end, the box begins to slide. 1. What is the coeﬃcient of static friction? 2. Once you have

2. ### help!!! physics

you want to nail a 1.6 kg board onto the wall of a barn. to position the board before nailing, you push it against the wall with a horizontal force to keep it from sliding to the ground. (a) if the coefficient of static friction

3. ### physics

Drag-race tires in contact with an asphalt surface have a very high coefficient of static fric.tion. Assuming a constant acceleration and no slipping of tires, estimate the coefficient of static friction needed for a drag racer to

4. ### Physics

A ladder 10-m long and weighing 50 N rests against a smooth vertical wall. If the ladder is just on the verge of slipping when it makes a 50 degree angle with the ground, find the coefficient of static friction between the ladder

1. ### Physics

One end of a uniform meter stick is placed against a vertical wall. The other end is held by a lightweight cord that makes an angle, theta, with the stick. The coefficient of static friction between the end of the meter stick and

2. ### physics

A 12 N horizontal force pushes a block weighing 5.0 N against a vertical wall (Fig. 6-26).The coefficient of static friction between the wall and the block is 0.60, and the coefficient of kinetic friction is 0.40. Assume that the

3. ### Physics

One end of a uniform 3.20-m-long rod of weight Fg is supported by a cable at an angle of θ = 37° with the rod. The other end rests against the wall, where it is held by friction as shown in the figure below. The coefficient of

4. ### physics

To measure the static friction coefficient between a 1.6-kg block and a vertical wall, the setup shown in the drawing is used. A spring (spring constant = 400 N/m) is attached to the block. Someone pushes on the end of the spring

1. ### physic 1

A person is trying to judge whether a picture (mass = 2.27 kg) is properly positioned by temporarily pressing it against a wall. The pressing force is perpendicular to the wall. The coefficient of static friction between the

2. ### maths

a ladder of length 3.5m rests against a vertical wall and makes an angle of 40 degrees with the floor. How far up the wall does the ladder reach?

3. ### Physics

A block with mass M rests on a frictionless surface and is connected to a horizontal spring of force constant k, the other end of which is attached to a wall. A second block with mass m rests on top of the first block. The

4. ### Physics - Forces

A 10 kg block is pressed against a vertical wall and held in place by a force F of 180 N, 37° above the horizontal. The coefficient of static friction μS=0.20. Find the magnitude and direction of the frictional force. The answer