Physics

A steel (Young's modulus 2.0 x 1011 N/m2) wire is strung between two supports attached to a ceiling. Initially, there is no tension in the wire when it is horizontal. A 98-N picture is then hung from the center of the wire, as the drawing illustrates, so the ends of the wire make angles of 26° with respect to the horizontal. What is the radius of the wire?

  1. 0
asked by Samantha

Respond to this Question

First Name

Your Response

Similar Questions

  1. physics

    A steel (Young's modulus 2.0 x 1011 N/m2) wire is strung between two supports attached to a ceiling. Initially, there is no tension in the wire when it is horizontal. A 88-N picture is then hung from the center of the wire, as the
  2. Physics

    A 2.2m of steel wire hangs vertically down from a support. A 1.5m length of brass wire of the same diameter is attached to the lower end of the steel wire.when a 10 kg mass is attached to the lower end of the brass wire a total
  3. Physics

    Steel is very stiff, and the Young's modulus for steel is unusually large, 2.0×1011 N/m2. A cube of steel 25 cm on a side supports a load of 85 kg that has the same horizontal cross section as the steel cube. What is the
  4. College Physics II

    A steel wire and a copper wire, each of diameter 2.000 mm, are joined end to end. At 48.0°C, each has an unstretched length of 2.000 m. The wires are connected between two fixed supports 4.000 m apart on a tabletop. The steel
  5. Physics

    A stainless-steel orthodontic wire is applied to a tooth, as in the figure below. The wire has an unstretched length of 3.42 cm and a radius of 0.14 mm. If the wire is stretched 0.13 mm, find the magnitude and direction of the
  6. physics

    A 4.0-m-long steel wire has a cross-sectional area of 0.050cm2. Its proportional limit has a value of 0.0016 times its Young's modulus. Its breaking stress has a value of 0.0065 times its Young's modulus. The wire is fastened at
  7. physics

    A mass of 12.7 kg is hanging by a steel wire 1.02 m long and 1.12 mm in diameter. If the mass is pulled down slightly and released, what will be the frequency of the resulting oscillations? Young's modulus for steel is 2.0 1011
  8. physics

    in the searler's metod to determine the young's modulus of a wire , a steel wire of length 156cm and diameter 0.054cm is taken as experimental wire. the average increase in length for 1 1/2 kg wt is found to be o.o5o cm.Then
  9. physics

    A light rigid bar is suspended horizontally from two vertical wires, one of steel and one of brass. Each wire is 2.00m long. The diameter of the steel wire is 0.60mm and the length of the bar AB is 0.20m. When a mass of 10.0kg is
  10. physics

    A light rigid bar is suspended horizontally from two vertical wires, one of steel and one of brass. Each wire is 2.00m long. The diameter of the steel wire is 0.60mm and the length of the bar AB is 0.20m. When a mass of 10.0kg is

More Similar Questions