A small electric immersion heater is used to boil 191.0 g of water for a cup of instant coffee. The heater is labeled 355.0 W, which means that it converts electrical energy to heat at this rate. Calculate the time required to bring this water from 12.0°C to the boiling point ignoring any heat losses.

  1. 👍
  2. 👎
  3. 👁
  1. heaterpower*time=masswater*c*(tfinal-12)

    solve for time (in seconds)

    1. 👍
    2. 👎

Respond to this Question

First Name

Your Response

Similar Questions

  1. Physics

    what is the required resistance of an immersion heater that will increase the temperature of 1.50 kg of water from 10 degrees C to 50 degrees C in 10 minutes while operating 120 V?

  2. physics

    What is the required resistance of an immersion heater that will increase the temperature of 1.5kg of water from 10*C to 50*C in 10 min while opperating at 120V? The answer is 24.2 ohms. I don't know what equation to use to solve

  3. math

    A water heater has a diameter of 18 inches. It sits in a drain pan that has a diameter of 22 inches and a height of 2 inches, as modeled in the diagram below. Water that leaks out of the water heater sits in the drain pan. Which


    45) George is making spaghetti for dinner. He places 4.01 kg of water in a pan and brings it to a boil. Before adding the pasta, he adds 58 g of table salt to the water and again brings it to a boil. The temperature of the salty,

  1. math

    Water is being poured into a conical cup that is 12cm tall. a) When the water in the cup is 9cm deep, what percentage of the cup is filled? b) When the cup is 75 percent filled, how deep is the water?

  2. Physics

    An electric heater which produces 900W of power is used to vaporize water. How much water at 100c can be changed to steam in 3 mins by the heater? (Heat of vaporization=2.26×106j/kg, specific heat capacity of water=4.2×103

  3. Physics

    An immersion heater of resistance R converts electrical energy into thermal energy that is transferred to the liquid in which the heater is immersed. If the current in the heater is I, the thermal energy transferred to the liquid

  4. Physics

    An electric space heater draws 15.5 A from a 120 V source. It is operated, on the average, for 4.0 h each day. (b) How much energy in kWh does in consume in 30 days? (c) At 11 per kWh, how much does it cost to operate the heater

  1. Physics

    A 210W heater is placed in 2KG of water. What temperature rise is produced if the heater is switched on for 200 seconds?

  2. physics

    An electric heater used to boil small amounts of water consists of a 25-Ω coil that is immersed directly in the water. It operates from a 60-V socket. How much time is required for this heater to raise the temperature of 0.50 kg

  3. physics

    The recovery time of a hot water heater is the time required to heat all the water in the unit to the desired temperature. Suppose that a 62-gal (1.00 gal = 3.79 x 10-3 m3) unit starts with cold water at 11 °C and delivers hot

  4. phy

    An electric kettle contains 1.5 kg of water at 100o C and powered by a 2.0 kW electric element. If the thermostat of the kettle fails to operate, approximately how long will it take for the kettle boil dry? (Take the specific

You can view more similar questions or ask a new question.