Physics

An electronic motor is revolving at 2000rpm. After 3sec, it is moving at 150rpm.
Determine the angular acceleration.
What is angular momentum of the electric motor if the rotational inertia is 18.kg.square meter in initial velocity?
In final velocity?
What is the average angular momentum?

  1. 👍 0
  2. 👎 0
  3. 👁 48
asked by Bob
  1. ω₀=2πn₀=2π•2000/60 rad/s
    ω=2πn =2π•150/60 rad/s
    ω=ω₀-εt
    ε= (ω₀-ω)/t=….
    L₀=I ω₀=…
    L=I ω=…
    L(ave) =(L+L₀)/2

    1. 👍 0
    2. 👎 0
    posted by Elena
  2. i thank thee for leh answer :D

    1. 👍 0
    2. 👎 0
    posted by Bob

Respond to this Question

First Name

Your Response

Similar Questions

  1. physics

    A 10g marble is spun so that it rolls at 150rpm around the inside of a steel tube. The tube has a 12cm diameter. Assume the rolling resistance is small enough for the marble to maintain 150rpm for several seconds. During this

    asked by Elizabeth on November 15, 2009
  2. physic

    A 69-cm-diameter wheel accelerates uniformly about its center from 150rpm to 320rpm in 4.4s . Determine angular acceleration?

    asked by Charles on March 29, 2014
  3. Electricity

    A motor running at its rated power provides 2.6 lb-ft torque at its rated speed of 2020 rpm. The motor draws 5.6-A from a 230-V supply at a phase angle of 37 degrees. Determine the following: The horsepower delivered by the motor,

    asked by Nick on January 24, 2008
  4. algebra

    The power (P) required to run a motor is equal to the voltage (E) applied to that motor times the current (I) supplied to the motor. If the motor data says the motor uses 180 watts of power and the voltage applied to the motor is

    asked by laquel on June 11, 2012
  5. Introduction to Graphic Design

    Hello! Thanks for checking my question out! ____ 10. Which of the following are reasons why it is important to properly recycle electronic equipment? Select all that apply. (3 points) a) Recycling electronic equipment conserves

    asked by Da Fash on September 26, 2017
  6. MECHANICAL ENGINEERING

    Need help with some engineering math problems? 1. You wish to determine the total system efficiency of your hydraulic press that is powered by an electric motor. The characteristics of the hydraulic press are as follows:

    asked by Anonymous on April 18, 2013
  7. Physics

    If a 65 kilogram load was raised 6 meters in 60 seconds determine the minimum rated wattage of the motor needed to accomplish this assuming the motor is 75% efficient. give your answer in W.

    asked by Joe on January 31, 2014
  8. physics

    A small motor draws a current of 1.76 A from a 110 V line. The output power of the motor is 0.20 hp. (a) At a rate of $0.060/kWh, what is the cost, in cents, of operating the motor for 4.0 h? (b) What is the efficiency of the

    asked by julie on March 14, 2011
  9. Physics

    A 120.0 volt motor draws a current of 7.60 A when running at normal speed. The resistance of the armature wire is 0.610. (a) Determine the back emf generated by the motor. 115.364 V (b) What is the current at the instant when the

    asked by Mary on October 9, 2007
  10. physics

    3- An electric motor can accelerate a Ferris wheel of moment of inertia (I =20 000 kg.m2) from rest to (10.0 rev/min) in (12.0 s). When the motor is turned off, friction causes the wheel to slow down from (10.0 to 8.00 rev/min) in

    asked by a on March 16, 2013

More Similar Questions