physics

1- a pipe of diamter 1cm carreiers water flowing at 1m/s. the end of the pipe is bplugged and there is a small holeon the top as shown which is 1mm diameter. How high does the water go?
*=hole
()____________*___()

2. you're indoors, with a door 1m wide and 2.5m high. the wind blows past the door at 1 m /s. what is the net force on the door and its direction? the density of air is 1.2kh/m^3.

You look at a faucent and notice that the strema narrows as it falls. Suppose that the initial water speed is v1 and the initial area of the water faucent opening is A1. Findd the area of the water stream when it has fallen a distance H. The density of water is 1kg/liter and 1 liter is a volume of a cuber w. sides 0.1m.

4- a balooon filled w. helium (density 0.1785 g/L) see previous question for desnity of air and what a liter is). Assuming a baloon of radius 10cm and ignoring the mass of the baloon how much weight could the baloon lift?

You would get faster responses if you posted questions one at a time, and showed some of your work.

(1) Since the pipe is blocked at the end and the hole is 1/10 the pipe diameter, the velocity of the water leaving the hole must be 100 times a m/s, or 100 m/s. That seems very high to me. Get the height H by setting the kinetic energy leaving the hole equal to the potential energy increase at height H:
V = sqrt (2 g H)

Use the bernoulli equation to get the pressure differential bwtween the two sides of the door. The pressure will be lower on the outside where the wind is blowing by. The pressure difference is
(1/2) (density) V^2.
Multiply that by the door area for the force, which will be outward

  1. 👍 0
  2. 👎 0
  3. 👁 94
asked by Devin

Respond to this Question

First Name

Your Response

Similar Questions

  1. physic

    you need to extend a 2.50 inch diameter pipe, but you only have 1.00 inch diameter pipe on hand.you make a fitting to connect these pipes end to end. if the water is flowing at 6.00cm/s in the wide pipe, how fast will it be

    asked by steve on July 20, 2010
  2. Physics

    Water is flowing in a pipe with a varying cross-section area, and at all points the water completely fills the pipe. At point 1 the cross-section area of the pipe is 0.080 m^2, and the magnitude of the fluid velocity is 2.50m/s.

    asked by Lycra on May 10, 2012
  3. physics

    A liquid of density 1354 kg/m^3 flows with speed 2.45 m/s into a pipe of diameter 0.29 m. The diameter of the pipe decreases to 0.05 m at its exit end. The exit end of the pipe is 7.82 m lower than the entrance of the pipe, and

    asked by michelle on November 29, 2012
  4. PHYSICS

    Water flowing out of a horizontal pipe emerges through a nozzle. The radius of the pipe is 1.5 cm, and the radius of the nozzle is 0.42 cm. The speed of the water in the pipe is 0.68 m/s. Treat the water as an ideal fluid, and

    asked by Anonymous on November 17, 2015
  5. Physics

    Water flows into one end of a horizontal, cylindrical pipe at 2.0 m/s. The pipe then narrows until its diameter at the opposite end is only 1/3 of that at the beginning. (a) What is the flow speed at the narrow end of the pipe?

    asked by Alex on April 15, 2017
  6. maths

    Pipe A can fill a pool in 15 minutes and pipe B alone can do it in 10 mibutes. Both the pipe are opened after 4 minutes water from pipe B stop flowing.In how much time will pipe A fill the part of the pool

    asked by Shivansh on November 6, 2016
  7. Physics

    An organ pipe that is closed at one end has a fundamental frequency of 122 Hz. There is a leak in the church roof, and some water gets into the bottom of the pipe, as shown in the Figure. The organist then finds that this organ

    asked by Physics Help! on November 20, 2011
  8. physics

    Water is flowing in a pipe with a circular cross-section area ,and at all point the water completely fills the pipe.At point 1 ,the cross sectiona are of pipe is 0.070 meter square and the fluid velocity is 3.50 meter per second.

    asked by cathrena on January 10, 2017
  9. Math - Calculus

    Water is flowing in a cylindrical pipe of radius 1 inch. Because water is viscous and sticks to the pipe, the rate of flow varies with distance from the center. The speed of the water at distance r inches from the center is

    asked by Elsi on December 15, 2012
  10. Physics

    The water flowing through a 1.9 cm (inside diameter) pipe flows out through three 1.3 cm pipes. (a) If the flow rates in the three smaller pipes are 24, 18, and 13 L/min, what is the flow rate in the 1.9 cm pipe? (b) What is the

    asked by Shawna on January 11, 2010

More Similar Questions