physics

A plastic tube allows a flow of 11.4 cm3/s of
water through it.
How long will it take to fill a 212 cm3 bottle
with water?
Answer in units of s

  1. 👍
  2. 👎
  3. 👁
  1. 212cm^3 รท 11.4cm^3/s = 18.6 s

    1. 👍
    2. 👎

Respond to this Question

First Name

Your Response

Similar Questions

  1. PHYSICS

    A tuning fork is set into vibration above a vertical open tube filled with water. The water level is allowed to drop slowly. As it does so, the air in the tube above the water level is heard to resonate with the tuning fork when

  2. Physics

    a modified U-tube: the right arm is shorter than the left arm. The open end of the right arm is height d = 10.0 cm above the laboratory bench. The radius throughout the tube is 1.60 cm. Water is gradually poured into the open end

  3. Physics- PLEASE!!

    A U-shaped tube is filled mostly with water, but some vegetable oil has been added to both sides of the U tube. On the right side of the tube, the depth of oil is 5.00 cm . On the left side of the tube, the depth of the oil is

  4. Physics

    A horizontal water pipe goes from a large diameter to a small diameter and then back to the first diameter as shown in the figure below. The level of water (8cm in the larger tube and 4 cm in the constricted tube) in the small

  1. Science

    Q16: A clear plastic cube with exactly the same index of refraction as water, is placed in a container of water. Would you be able to see the plastic cube in the water if you looked at it from an angle? Please explain why or why

  2. College Physics

    2 questions: a)Assuming that water has a density of exactly 1 g/cm3 (cubed), find the mass of one cubic meter of water in kilograms. b)Suppose that it takes 10 hours to drain a container of 5700m3 (cubed) of water. What is the

  3. Fluid mechanics

    A vertical tube 3 meters long with one end closed, is inserted vertically with the open end down into a tank of water until the open end is submerged to a depth of one meter. What is the height of water inside the tube?

  4. general physics

    A meat baster consists of a squeeze bulb attached to a plastic tube. When the bulb is squeezed and released, with the open end of the tube under the surface of the basting sauce, the sauce rises in the tube to a distance h, as the

  1. chemistry

    The density of a certain type of plastic is 0.89 g/cm3. If a sheet of this plastic is 10.0 m long, 1.0 m wide, and 1.0 cm thick, what is its mass?

  2. physics

    a modified U-tube: the right arm is shorter than the left arm. The open end of the right arm is height d = 10.0 cm above the laboratory bench. The radius throughout the tube is 1.60 cm. Water is gradually poured into the open end

  3. physics

    Water flows steadily along a uniform flow tube of cross-section 30cm^2. The static pressure is 1.20 x 10^5 Pa and the total pressure is 1.28 x 10^5 Pa. Calculate the flow velocity and the mass of water per second flowing past a

  4. Physics

    A vertical tube with a tap at the base is filled with water, and a tuning fork vibrates over its mouth. As the water level is lowered in the tube, resonance is heard when the water level has dropped 18 cm, and again after 54 cm of

You can view more similar questions or ask a new question.