# chemistry

A 20.0 mL sample of 0.687 M HBr is titrated with a 0.216 M NaOH solution. The pH after the addition of 10.0 mL of NaOH is __________.

1. 👍 0
2. 👎 0
3. 👁 388
1. initial mols HBr = M x L = about 0.014
but you need to do them more accurately.
........NaOH + HBr ==> NaBr + H2O
I.........0....0.014....0.......0
C.......-0.002..-0.002..0.002..0.002
E.........0.....0.0120...0.002.0.002

So what you have at 10.0 mL is a solution of HBr which is a strong acid (100% ionized); therefore, (H^+) = (HBr) so pH = -log(HBr)
Note: (HBr) = mols/L = 0.012/(0.010+0.020) = ?

1. 👍 0
2. 👎 0
2. Thank you so much that cleared up a lot!

1. 👍 0
2. 👎 0

## Similar Questions

1. ### chemistry

A volume of 100mL of 1.00 M HCl solution is titrated with 1.00 M NaOH solution. You added the following quantities of 1.00 M NaOH to the reaction flask. Classify the following conditions based on whether they are before the

asked by Anon on August 6, 2012
2. ### Chemistry

1-A sample of potassium hydrogen oxalate, KHC2O4, weighing 0.717 g, was dissolved in water and titrated with 18.47 mL of an NaOH solution. Calculate the molarity of the NaOH solution. 2-A 35 mL drinking water sample, whose pH is

asked by Hiba on June 11, 2020
3. ### chemistry

A 27.00 mL sample of an unknown H3PO4 solution is titrated with a 0.110 M NaOH solution. The equivalence point is reached when 25.78 mL of NaOH solution is added. What is the concentration of the unknown H3PO4 solution? The

asked by Amanda on September 27, 2012
4. ### chemistry

25.0g of 5.0% (by mass) acetic acid solution are titrated with 0.300 M NaOH. What volume of NaOH will be needed to neutralize this sample?

asked by Cynthia on May 28, 2010
5. ### Chemistry

A 0.1873 g sample of a pure, solid acid, H2X was dissolved in water and titrated with 0.1052 M NaOH solution. The balanced equation for the neutralization reaction occurring is H2X(aq) + 2NaOH(aq) ¨ Na2X(aq) + 2H2O(l) If the

asked by Lauren on May 11, 2011
1. ### Chemistry

One commercial method used to peel potatoes is to soak them in a solution of NaOH for a short time, remove them from the NaOH, and spray off the peel. The concentration of NaOH is normally in the range of 3 to 6 M. The NaOH is

asked by Chin on January 12, 2011
2. ### chemistry

A sample of potassium hydrogen oxalate, KHC2O4, weighing 0.717 g, was dissolved in water and titrated with 18.47 mL of an NaOH solution. Calculate the molarity of the NaOH solution.

asked by mary on April 27, 2015
3. ### chemistry

a solid sample of impure Ba(OH)2 is added to 400.0 mL of 0.5000 M of aqueous HBr, a strong acid. the remaining solution was acidic. it was then titrated to equivalence point with 120.0 mL of 0.5000 M of NaOH solution. what mass of

asked by mel <3 on February 26, 2011
4. ### Chemistry

15.00mL sample of a solution of H2SO4 of unknown concentration was titrated with 0.3200 N NaOH. The titration required 21.30mL of the base. What was the normality of the acid solution? what was the molarity of the acid solution?

asked by Mark on October 5, 2015
5. ### CHECK MY CHEMISTRY WORK PLEASE ASAP

1. You have been given a sample of unknown molarity. Calculate the molarity of a solution which has been prepared by dissolving 8.75 moles of sodium chloride in enough water to produce a solution of 6.22l. 2. You have a sample

asked by David on January 10, 2017
6. ### Chemistry

Question: A 0.400 g sample of propionic acid was dissolved in water to give 50.00 mL of solution. This solution was titrated with 0.150 M NaOH. what was the pH of the solution when the equivalence point was reached? I'm not really

asked by Eliz on April 15, 2009