# Chemistry

the mass of the crucible is 19.73 g fill the crucible with CuSO4 which was 26.44 g Heat the crucible until the water is released it weighed 23.40 g So now, how many moles of water is removed? The number of moles of CuSO4 that after dissolution rest? determine the number of H2O molecules, namely x, that is bound in CuSO4? set the equation for the decomposition reaction? find the correct value of x at. Calculate the percentage? is the hydration of CuSO4 exo-or endothermic?

1. 👍 0
2. 👎 0
3. 👁 337
1. So you want someone to do all of this? Show what you know to do and explain what you don't understand about the rest of the problem.

1. 👍 0
2. 👎 0

## Similar Questions

1. ### chemistry

was hoping someone can help me check if these answers make sense for a silver copper alloy lab. 3. Why donâ€™t you have to weigh the sodium chloride on a sensitive balance? This one I am not sure about, It is because an excess of

2. ### college chemistry

Mg and O lab how will the relative number of moles of mg and o be affected if the following procedural errors are made? a)crucible is not brought to constant mass before the Mg is added. b)water is not added after the first

3. ### General chemistry

1) How high above the inner blue cone of the burner flame should the crucible be when the Mg is heated? 2) What should you do if you see white smoke rising from the crucible in the early stages of heating the Mg? 3) How will you

the crucible is not fired, as the procedure suggests, but had retained some impurities from previous use(or it could be oily smudges from fingers). the mass of the "dirty" crucible is recorded. however the impurities are burned

1. ### chemistry

mass of crucible- 26.4574g mass of crucible and hydrated sample- 27.7617g mass of hydrated sample 1.3043g mass of crucible and dehydrated sample- 27.5693g mass of dehydrated sample- 1.1119g mass of filter paper- 0.7089g mass of

2. ### Composite Materials

Can someone please help with this problem? A burnout test was performed to determine the volume fractions of constituents in a glass/epoxy composite. The following observations were made: Weight of empty crucible = 47.6504 g

3. ### General Chemistry

The formula of a compound of lead (Pb) and sulfur (S) was determined using the method in this module. A sample of Pb was weighed into a crucible and covered with finely powdered S. The crucible was covered and heated to allow the

4. ### English

Read this passage from Act 1, Part 7, of The Crucible. ABIGAIL: I want to open myself! (They turn to her, startled. She is enraptured, as though in a pearly light.) I want the light of God, I want the sweet love of Jesus! I danced

1. ### chemistry

A sample of a hydrate of CuSO4 with a mass of 250 grams was heated until all the water was removed. The sample was then weighed and found to have a mass of 160 grams. What is the formula for the hydrate? CuSO4 * 10 H2O CuSO4 * 7

2. ### Chemistry

A hydrated MgSO4 salt, weighing 3.211g, is heated in a crucible until reaching a constant weight. The weight of the anhydrous MgSO4 is 1.570 grams. 1. Calculate the moles of H20 removed and the moles of anhydrous MgSO4 remaining

3. ### Chemistry :/

Experiment 1 results: mass of crucible 88g mass of hydrate 93g mass of salt 91.196g 1. Calculate the following: a:mass of water in the hydrate sample (g) b:number of moles of water in the sample c:mass of pure salt in the sample

4. ### Chemistry

A student made a determination of the empirical formula ot tungsten oxide (WO) produced by the total ignition of air of a smaple of metallic Tungsten. From the lab: Weight of crucible 11.120g weight of tungsten 8.820 weight of