science

Does adding boiled, deionized water to the titrating flask to wash the wall of the erlenmeyer flask and the buret tip increase, decrease, or have no effect on the Ksp value of the Ca(OH)2?

  1. 👍
  2. 👎
  3. 👁

Respond to this Question

First Name

Your Response

Similar Questions

  1. Science

    Why does the design of the vacuum flask minimize heat transfer by conduction? A)One flask is smaller than the other flask. B)One flask is more reflective than the other flask. C)There is no air between the two flask. D)The two

  2. Chemistry

    Which of the following systems would be considered to be at equilibrium: I. an open flask with 2.0 mL of perfume II. a closed flask with 10 mL of water III. an open flask with 10 mL of water IV. a closed flask with an ice cube and

  3. chemistry

    Lab: Determining the Quantity of Vitamin C in Fruit Juice Vitamin C, also called ascorbic acid, is commonly found in commercial fruit juices and drinks. In this activity you will analyze data collected from a titration analysis of

  4. Chemistry PLEASE HELP!!

    Procedure: 1. Calculate the mass of iron(II) ammonium sulfate hexahydrate, Fe(NH©þ)©ü(SO©þ)©ü*6H©üO (MW = 392.14) required to make 100 mL of solution that is 0.2M in Fe©÷⁺ ions. You will be asked to show your

  1. Chem

    a 4.369g sample of metal is placed in a flask. water is added to the flask and the total volume in the flask is read to be 126.4ml. the mass of the water, flask, and metal is 268.5g. if the mass of the flask is 139.3g and the

  2. Chemistry

    Can you check my answers? Thanks!!!! What would happen to the volume-to-temperature ratio if: 1. One student failed to replenish the boiling water in the boiling-water bath as the flask was being heated. At the end of the 6 min of

  3. Chemistry

    Explain how the calculated molarity of the potassium permanganate would be affected by each of the following experimental errors. In each case, you must also state if the calculated molarity is higher or lower than the actual

  4. Math

    An industrial dishwasher takes 4.8 litres of water to wash a full load of dishes. If you were to wash full loads, how much water would you use? I am very confused on how to begin figuring this math problem out. Can you assist?

  1. chemistry

    PLEASE NOTE: Titration requires several steps in order to obtain exact results. The procedures described in this lab assume that you have already done the TITRATION TUTORIAL and are familiar with the technique. 1. Prepare the NaOH

  2. Chemistry

    A sealed flask contains 0.60 g of water at 28 degrees celcius. The vapor pressure of water at this temperature is 28.36 mmHg. What is the minimum volume of the flask in order that no liquid water be present in the flask?

  3. chemistry

    A student obtained a clean, dry, glass stoppered flask. The weight of the flask and stopper was 32.634 g. The student filled the flask with water and obtained a mass for the full stoppered flask of 59.479 g. The density of water

  4. Chemistry

    A student obtained a clean, dry glass- stoppered flask. She weighed the flask and stopper on an analytical balance and found the total mass to be 33.695 g. She then filled the flask with water and obtained a mass for the full

You can view more similar questions or ask a new question.