science

What is the meaning of calibration?

asked by erode kathirvel
  1. Calibration is checking the accuracy of a measurement device, using an accurate standard.

    posted by drwls

Respond to this Question

First Name

Your Response

Similar Questions

  1. Science

    Propose a series of concentration to be used for calibration curve. If an unknown solution produced a result outside the range of the calibration curve, how could this be solved?
  2. ANALYTICAL CHEMISTRY

    Explain the following statement: "The validity of a chemical analysis ultimately depends on measuring the response of the analytical procedure to known standards." (b) Calibration curves are necessary in many chemical measurements
  3. Chemistry

    How do you create a calibration curve? How do you use a calibration curve to convert absorbance to concentration in mg/mL?
  4. Chemistry

    I'm trying to do a lab, and I need to find the concentration of FeSCN+2 in five solutions based the calibration curve and the absorption. I have a calibration curve, the number of mLs and initial moles of Fe+3 and SCN-, the
  5. chemistry-calibration curve

    what does the calibration curve tell you about the spectrophotometer?
  6. Chem

    Calibration data for a bromide ion-selective electrode (ISE) was collected and recorded below. The potential of the ISE was measured against a saturated calomel electrode (SCE). All solutions were buffered at a pH of 7.56. A
  7. CHM Lab

    Calibration of a 50 ml buret (10 ml,15 ml,20ml, 25 ml,30ml,35ml,40ml,45ml,50ml)(repeated the procedure 3 times) for experimental ; i have observed vol(ml) , temp.C ,for true i have mass(g), true vol. ml and for calibration i found
  8. Chemistry

    Do I solve this by multiplying 1.8645 by 1.14??The equation of your calibration curve from a spectrophotometry experiment was y = 1.8645x. Assuming your calibration curve is set up exactly like it was in lab (concentration in mM
  9. Chem

    Calibration of a glass electrode gave a reading of 139.3 mV with 0.05 m potassium dihydrogen citrate buffer standard (pH = 3.766) and a reading of -79.0 mV with 0.08 m HEPES, 0.08 m NaHEPES, 0.08 m NaCl buffer standard (pH =
  10. science

    What is the meaning of cell structure because i can't find the meaning anywhere.

More Similar Questions