Math

Is it possible to have a 15/16 inch pipe with an inside diameter of 31/32 inch?

No

  1. 👍
  2. 👎
  3. 👁
  1. Correct:)

    1. 👍
    2. 👎

Respond to this Question

First Name

Your Response

Similar Questions

  1. physics

    Water moves through a constricted pipe in steady, ideal flow. At the lower point shown in figure below, the pressure is P1 = 1.75X104 Pa and the pipe diameter is 6.00 cm. At another point y = 0.250 m higher, the pressure is P2 =

  2. Physics

    Please someone help..A horizontal pipe 10.0cm in diameter has a smooth reduction to a pipe 5.0cm in diameter. If the pressure of the water in the large pipe is 80000Pa and the pressure in the small pipe is 60000Pa at what rate

  3. Physics

    For an ideal fluid flowing through a horizontal pipe, Bernoulli's principle and the continuity equation state that the pressure within the pipe does which of the following? Pressure descreased pipe diameter increase?

  4. Fluid Mechanics

    Water flows into a cylindrical tank through pipe 1 at a rate of 25 ft/s and leaves through pipe 2 at 10 ft/s and through pipe 3 at 12 ft/s. Pipe 4 is an open air vent. Internal diameters of the pipes are: D1=3 in, D2= 2 in, D3=2.5

  1. Physics

    The water flowing through a 1.9 cm (inside diameter) pipe flows out through three 1.3 cm pipes. (a) If the flow rates in the three smaller pipes are 24, 18, and 13 L/min, what is the flow rate in the 1.9 cm pipe? (b) What is the

  2. maths

    To fill a swimming pool two pipes are to be used.If the pipe of larger diameter I'd used for 4 hours and the pipe of smaller diameter for 9 hours only half the pool can be filled .Find ,how long it would take for each pipe to fill

  3. Math

    If the outer diameter of a metal pipe is 2.84 inches and the inner diameter is 1.94 inches, the thickness of the metal is A. 0.45 of an inch B. 0.90 of an inch C. 1.94 inches D. 2.39 inches

  4. Physics

    A horizontal water pipe goes from a large diameter to a small diameter and then back to the first diameter as shown in the figure below. The level of water (8cm in the larger tube and 4 cm in the constricted tube) in the small

  1. Thermodynamics and Heat Transfer

    A steam pipe is 75 mm external diameter and is 80 m long. It conveys steam at a rate of 1000 kg/h at a pressure of 2 Mpa. The steam enters the pipe with a dryness fraction of 0.98 and is to leave the pipe with a dryness of not

  2. physic

    you need to extend a 2.50 inch diameter pipe, but you only have 1.00 inch diameter pipe on hand.you make a fitting to connect these pipes end to end. if the water is flowing at 6.00cm/s in the wide pipe, how fast will it be

  3. Physics

    A horizontal pipe, 10 cm in diameter, has a smooth reduction to a pipe 5 cm in diameter. If the pressure of the water in the larger pipe is 8.00 104 Pa and the pressure in the smaller pipe is 6.00 104 Pa, what is the flow speed of

  4. physics

    Water flows through a 4.0-cm-diameter horizontal pipe at a speed of 1.3m/s . The pipe then narrows down to a diameter of 2.0cm . Ignoring viscosity, what is the pressure difference between the wide and narrow sections of the pipe?

You can view more similar questions or ask a new question.