# Chem

Consider the following reaction was found to be the 0th order to A and 2nd order to B.

2A(cr) + 3B(aq) -->A2B3(cr)

Write a rate law equation for the reaction rate of A with B.

1. 👍 0
2. 👎 0
3. 👁 49
1. rate = k*[A]o[B]2
OR you may omit the A terms since A raised to the zero power is 1. The "trick" to the problem, I suspect, is that many will write it as (A)^2*(B)^3.

1. 👍 0
2. 👎 0
2. Ok, thanks.

Q1: If [A] is doubled how does the reaction rate change?

A: I put no change because 0th order cancels it out.

Q2: If [B] is doubled how does the reaction rate change?

A: I put it increases by a factor of 4 because of the squared term.

Q3: How would increase pressure effect the reaction rate?

A:???

1. 👍 0
2. 👎 0
3. Now that I look at Q3 I am thinking it is going to increase it, but not sure by what factor?

1. 👍 0
2. 👎 0
4. The answer to A is correct since it's zero order with respect to A. The answer to B is correct since 2^2 = 4.
Look at the equation. A is Cr which I assume means crystalline and that means a solid. B is aq which I assume means a liquid and A2B3 is cr which again I assume is a solid. Pressure will have an effect if reactants or products are gases; however, pressure has no effect on solids and essentially no effect on liquids. So increased pressure, I think, will have no effect on the rate of this reaction. .

1. 👍 0
2. 👎 0

## Similar Questions

8. The half-life of a reaction was found to be inversely dependent on the concentration of the starting material. Thus, we can say that a. the reaction is zero order b.the reaction is first order c.the reaction is second order d.

asked by Hannah on February 20, 2012
2. ### chemistry

The half-life of a reaction was found to be inversely dependent on the concentration of the starting material. Thus, we can say that a. the reaction is zero order b. the reaction is first order c. the reaction is second order d.

asked by elvis on February 18, 2012
3. ### chemistry

The half-life of a reaction was found to be inversely dependent on the concentration of the starting material. Thus, we can say that a. the reaction is zero order b. the reaction is first order c. the reaction is second order d.

asked by elvis on February 18, 2012
4. ### chemistry

The half-life of a reaction was found to be inversely dependent on the concentration of the starting material. Thus, we can say that a. the reaction is zero order b. the reaction is first order c. the reaction is second order d.

asked by elvis on February 17, 2012
5. ### differential equations

Consider the 2nd order differential equation: x''(t)=-x-A(x^2-1)x'(t) x(0)= 0.5 x'0)= 0 ''= 2nd order,'= 1st order where A is a positive constant.As the value of A increases this equation becomes increasingly stiff. Convert this

asked by Rikki on November 16, 2011
6. ### chemistry, chemical kinetics

I keep getting these questions wrong, could someone please help. Thanks so much. Question 1 For the following overall reaction, the rate constant is 3.4x10^-2. A(g)+ 2B -> 2C + D What may be the rate reaction? Question 2 The rate

asked by student on July 2, 2010
7. ### chemistry

x + 2y ---> products is first order in c and 2nd order in y. what are the units of K, the specific rate constant, if the reaction rate is expressed in units of moles per liter per sec. I know the answer is M.s^-1^ but I don't

asked by Audrey on December 12, 2010
8. ### Chemistry

A reaction in which X and Y form products was found to be second order in X and first order in Y. By what factor will the rate of the reaction change if [X] is doubled and [Y] is tripled? a. 10 b. 12 c. 20 d. 2

asked by Student on February 19, 2015
9. ### chemistry help?!

Which statement correctly pairs the order of a reaction with the units for the rate constant? A. third order; s/M B. zero order; 1/(M2) C. second order; 1/(M•s) D. first order; 1/M

asked by Jessie on August 19, 2016
10. ### Chemistry (kinetics)

None of the orders in this reaction were 0 order; however, reactions can be 0 order. Using the idea of a reaction mechanism and rate limiting step, explain how a reaction can be 0 order for a substance.

asked by Shruti on December 5, 2012

More Similar Questions