tv cable

Hi,
Is it possible for me to buy a tv cable wire separately and use it for the tv I currently have?
I just moved from a different house and i can't find where i put the wire.

  1. 👍
  2. 👎
  3. 👁
  1. Yes

    1. 👍
    2. 👎

Respond to this Question

First Name

Your Response

Similar Questions

  1. Physics

    In a repair shop a truck engine that has mass 429 kg is held in place by four light cables (Figure 1) . Cable A is horizontal, cables B and D are vertical, and cable C makes an angle of 37.1∘ with a vertical wall. Tension in

  2. Physics

    Joe wishes to hang a sign weighing 730 N so that cable A, attached to the store, makes a 30.0° angle, as shown below. Cable B is horizontal and attached to an adjoining building. What is the tension in cable B?

  3. physics

    Consider two copper wires with the same cross-sectional area. Wire A is twice as long as wire B. How do the resistivities and resistances of the two wires compare? CHECK ALL THAT APPLY Wire A and wire B have the same resistance.

  4. Physics

    A wire of 5.0m and diameter 2.0mm,extends by 0.25mm when a force of 50N was stretch it from it's end calculate a.the stress on the wire. b.the strain in the wire. c.the young's modulus of elasticity of the wire

  1. physics

    A tow truck is connected to a 1500 kg car by a cable that makes a 27 degree angle to the horizontal. If the truck accelerates at 0.58 m/s^2, what is the magnitude of the cable tension? Neglect friction and the mass of the cable.

  2. Physics

    A massive steel cable drags a 20kg block across a horizontal, frictionless surface. A 100N force applied to the cable causes the block to reach a speed of 4.2m/s in a distance of 2.1m . What is the mass of the cable?

  3. AP Physics

    A certain length of wire has a resistance of 21 ohms. This wire is melted down and from the same volume of material a new wire is formed that is three times longer than the original wire. What is the resistance of a new wire?

  4. Physics

    1. A force of 40N at the end of a wire of length 4m and diameter 2mm process and extension of 0.24mm. Calculate; (a) stress on the wire (b) strain in the wire (c) Young's Modulous for the material of the wire (π=3.14)

  1. Physics

    A tow truck is pulling a car out of a ditch by means of a steel cable that is 9.3 m long and has a radius of 0.50 cm. When the car just begins to move, the tension in the cable is 1070 N. How much has the cable stretched? Answer

  2. Trigonometry

    A communications tower is located at the top of a steep hill, as shown. The angle of inclination of the hill is 58°. A guy wire is to be attached to the top of the tower and to the ground, 50 m downhill from the base of the

  3. physics

    A force of 40N is applied at the end of a wire 4m long and produces an extension of 0.24mm. If the diameter of the wire is 2.00mm calculate the stress on the wire and strain in the wire. With full workings please

  4. algebra

    A wire to be attached to support a telephone pole. Because of surrounding buildings, sidewalks and roadways, the wire must be anchored exactly 21 feet from the base of the pole. Telephone company workers have only 28 feet of

You can view more similar questions or ask a new question.