science

how grams it would take to fill the buret to 35mL? is this would take more or less than for butane? what do you think causes this value to be different from the value for butane?

  1. 👍 0
  2. 👎 0
  3. 👁 103
asked by baby1
  1. We don't know what experiment you are discussing. You must give details to your questions.

    1. 👍 0
    2. 👎 0
    posted by DrBob222

Respond to this Question

First Name

Your Response

Similar Questions

  1. Science

    How can i find the observed volume? lets say I'm using a 50 ml beaker and I fill it up with 35 ml? would it be 35ml or 50ml?

    asked by Boboruto on September 18, 2018
  2. Analytical CHM Lab

    I am filling out my neutralization titration data sheet and i did not understand how to find buret correction (ml) and corrected volume(ml) and Molarity of NaOH without buret correction and as well as with buret correction. in the

    asked by Jessy on September 19, 2014
  3. CHM Lab

    Calibration of a 50 ml buret (10 ml,15 ml,20ml, 25 ml,30ml,35ml,40ml,45ml,50ml)(repeated the procedure 3 times) for experimental ; i have observed vol(ml) , temp.C ,for true i have mass(g), true vol. ml and for calibration i found

    asked by Jesi on September 17, 2014
  4. Chemistry

    A student collected H2 gas in a buret by displacing water at 22.0 °C. The buret could not be submerged deep enough in a water bath to equalize the pressure. The water level in the buret was 18.2 cm above the water level in the

    asked by Amy on January 23, 2013
  5. Chemistry

    A student collected H2 gas in a buret by displacing water at 22.0 °C. The buret could not be submerged deep enough in a water bath to equalize the pressure. The water level in the buret was 18.2 cm above the water level in the

    asked by Amy on January 23, 2013
  6. Chemistry

    A buret is partially filled with NaOH solution, to a volume of 1.14mL. A 20-mL sample of 0.1011 M HCl is titrated to a faint pink phenolphthalein endpoint. The final buret buret reading is 22.37mL. What is the molarity of the NaOH

    asked by Michelle on March 27, 2015
  7. CHEMISTRY

    If you use a dirty buret, the titrant leaves drops of solution behind as the meniscus descends during delivery of the solution. The volume actually delivered by the buret will be __________ the volume your readings of the buret

    asked by Anonymous on October 7, 2014
  8. chemistry

    How many grams of kmn04 are contained in 35ml of 0.05N kmn04 used in the following reaction in basic solution. the answer 0.0922g who helps

    asked by Fai on February 9, 2013
  9. chemistry

    A volume of 12.47 mL of 0.1080 M NaOH solution was used to titrate a 0.583 g sample of unknown containing K2HPO4. What is the percent by mass of K2HPO4 in the unknown? In this problem what mass of sample in grams would be needed

    asked by lovely on December 3, 2013
  10. chemistry about buret

    In the experiment of buret calibration, what is the importance of having total buret correction? And does the density of the water at a specific temperature affect this corrections?

    asked by xavier on July 2, 2013

More Similar Questions