# physics

An ideal monatomic gas initially has a temperature of 338 K and a pressure of 6.96 atm. It is to expand from volume 435 cm3 to volume 1310 cm3. If the expansion is isothermal, what are (a) the final pressure (in atm) and (b) the work done by the gas? If, instead, the expansion is adiabatic, what are (c) the final pressure (in atm) and (d) the work done by the gas?

1. 👍
2. 👎
3. 👁

## Similar Questions

1. ### Physics

FIGURE: h t t p : / / g o o . g l / a 7 j C F The figure is a PV diagram for a reversible heat engine in which 1.0 mol of argon, a nearly ideal monatomic gas, is initially at STP (point a). Points b and c are on an isotherm at T =

2. ### chemistry

If I contain 3 moles of gas in a container with a volume of 60 liters and at temperature of 400 K, what is the pressure inside the container? Ideal Gas Law: PV=nRT I know I'm given the volume, temperature, and numbers of moles of

3. ### Physics

The drawing shows an ideal gas confined to a cylinder by a massless piston that is attached to an ideal spring. Outside the cylinder is a vacuum. The cross-sectional area of the piston is A = 2.50 10-3 m2. The initial pressure,

4. ### physics

an ideal monatomic gas is allow to expand slowly until its presssure is reduced to exactly half its original value. By what factor does the volume change if the pressure is (1) isothermal (2) adiabatic

1. ### physics

A 1.80 mol sample of an ideal diatomic gas at a pressure of 1.20 atm and temperature of 410 K undergoes a process in which its pressure increases linearly with temperature. The final temperature and pressure are 710 K and 1.83

2. ### Physics

A monatomic ideal gas expands from 1.00m^3 to 2.50m^3 st a constant pressure of 2.00x10^5 Pa. Find the change in the internal energy of the gas.

3. ### Physics

A sample of a monatomic ideal gas is originally at 20 °C. Calculate its final temperature of the gas if the pressure is doubled and volume is reduced to one-fourth its initial value.

4. ### Physics

A quantity of monatomic ideal gas expands adiabatically from a volume of 2.0 liters to 6.0 liters. If the initial pressure is P0, what is the final pressure?

1. ### science

As the pressure of a fixed mass of a gas is increased at constant temperature, the density of the gas increases? As the absolute temperature of a fixed mass of an ideal gas is increased at constant pressure, the volume occupied by

2. ### Physics

A heat engine using a monatomic gas follows the cycle shown in the pV diagram to the right. The gas starts out at point 1 with a volume of 233 cm3, a pressure of 235 kPa, and a temperature of 317 K. The gas is held at a constant

3. ### Physics

FIGURE: h t t p : / / g o o . g l / a 7 j C F The figure is a PV diagram for a reversible heat engine in which 1.0 mol of argon, a nearly ideal monatomic gas, is initially at STP (point a). Points b and c are on an isotherm at T =

4. ### Physics 2

A 1.00-L insulated bottle is full of tea at 88.0°C. You pour out a mug of tea and immediately screw the stopper back on the bottle. Find the change in temperature of the tea remaining in the bottle that results from the admission