Physics

i cant get this right. what is the measured resistance of a 1000ohm, 500ohm and a 100 ohm resistor. and there % error

  1. 👍
  2. 👎
  3. 👁
  1. Is it possible you need to measure those resistors?

    1. 👍
    2. 👎
    👤
    bobpursley

Respond to this Question

First Name

Your Response

Similar Questions

  1. Physics

    An object is released from rest and falls in free fall motion. The speed v of the object after it has fallen a distance y is given by v2 = 2gy. In an experiment, v and y are measured and the measured values are used to calculate

  2. Engineering Science (Physics)

    A platinum coil has a resistance of 3.146(ohms) at 40'C and 3.767(ohms) at 100'C. Find the resistance and the temperature coefficient of resistance at 0'C. Thanks in anticipation

  3. circuits 2

    a 25ohm resistor connected in series with a coil of 500ohm resistance and 150mH inductance. What is the power factor of the circuit? NOTE: since not given, assume a standard electrical frequency of 60Hz.

  4. Differential Equations

    A projectile was launched from the ground with a certain initial velocity. Militaries used a radar to determine the vertical coordinate y(t) of the projectile for two moments of time t measured in seconds from the moment when the

  1. Physics

    A car drives at 15 m/s and has an air resistance force of 277 N. What is the air resistance force at 30 m/s? A truck drives at 9.7 m/s and has an air resistance force of 380 N. What is the air resistance force at 32 m/s? A 85.0 kg

  2. Physics resistance question

    A piece of copper wire of resistance R is cut into 10 equal lengths. These parts are connected in parallel. How does the joint resistance of the parallel combination compare with the original resistance of the single wire?

  3. Calculus 1

    If two resistors with resistances R1 and R2 are connected in parallel, as in the figure below, then the total resistance R, measured in ohms (Ω), is given by 1/R= 1/R1+ 1/R2. If R1 and R2 are increasing at rates of 0.3 Ω/s and

  4. Physics

    When potential difference across the terminals of a battery is measured using an analogue voltmeter of resistance 95 ohms, the reading on the voltmeter is 5.70 V. When it is measured using a very high resistance digital meter the

  1. physics

    A certain copper wire has a resistance of 12.0 \Omega.At what point along its length must the wire be cut so that the resistance of one piece is 5.0 times the resistance of the other?

  2. physics

    An object is released from rest and falls in free fall motion. The speed v of the object after it has fallen a distance y is given by v2 = 2gy. In an experiment, v and y are measured and the measured values are used to calculate

  3. Solar Energy

    Consider a PV module with the following parameters as measured at STC (Standard Testing Conditions): Voc = 55 V; Isc = 5 A; Impp = 4.7 A; Fill Factor = FF = 75% ; Efficiency = 19.75%. Suppose that under normal operation at STC

  4. Algebra

    Two lamps can be connected to a battery in a circuit in series or in parallel. You can calculate the total resistance RT (t is down from r) in a circuit if you know the resistance in each lamp. Resistance is measured in ohms. For

You can view more similar questions or ask a new question.