9th grade science

A strong acid, HBr, has been dissolved into a beaker of water. If the solution is known to be 0.000 001 M, what is the pH solution?

  1. 👍 1
  2. 👎 0
  3. 👁 398

Respond to this Question

First Name

Your Response

Similar Questions

  1. Chem

    The mass of a beaker is 5.333g. After 5.00 mL of a concentrated hydrochloric acid solution is pipetted into the beaker, the combined mass of the beaker and the hydrochloric acid sample is 11.229 g. From the data, what is the


    HOW CAN U TELL IF HNO3 +KNO3 IS A BUFFER SOLUTION A buffer solution must contain a weak acid and its conjugate base OR a weak base and its conjugate acid. HNO3 is a strong base and KNO3 is the salt of a strong base (KOH) and a

  3. Chem

    A volume of equimolar strong acid like HCl is mixed with an equal volume of equimolar strong base like NaOH in a beaker of water. What exists after the reaction?

  4. Chemistry

    1. Hydrogen bromide(HBr) is a strong, highly corrosive acid and what is the pOH of a 0.0375M HBr solution? a)12.57 b)12.27 c)1.73 d)1.43 I can't fogure out what the answer should be as I don't know whether 0.0375M is the [H^+] or

  1. Science

    G) The mass of a beaker is 40.94 g. After 5.00 mL of concentrated hydrochloric acid solution is pipetted into the beaker, the combined mass of the beaker and hydrochloric acid is 46.92 g. From the data, calculate the density of

  2. o chem

    Impure acetanilide was dissolved in the required amount of hot water. The clear solution in a beaker was immediately placed in an ice-water bath, instead of being allowed to cool down slowly. What would be the result of cooling

  3. Analytical Chemistry

    Carbon dioxide dissolves in water to form carbonic acid, which is primarily dissolved CO2. Dissolved CO2 satisfies the equilibrium equation. CO2(g) CO2(aq) The acid dissociation constants listed in most standard reference texts

  4. chemistry

    A 125.0 mg sample of an unknown, monoprotic acid was dissolved in 100.0 mL of distilled water and titrated with a 0.050 M solution of NaOH. The pH of the solution was monitored throughout the titration, and the following data were

  1. Chemistry

    A sample of solid Ca(OH)2 is stirred in water at 30°C until the solution contains as much dissolved Ca(OH)2 as it can hold. A 100.-mL sample of this solution is withdrawn and titrated with 5.00 X 10^-2 M HBr. It requires 48.8 mL

  2. chemistry

    1. When performing this experiment, a student mistakenly used impure KHP to standardize the NaOH solution. If the impurity is neither acidic nor basic, will the percent by mass of acetic acid in the vinegar solution determined by


    How would the calculated value of the molar mass of an unknown acid be affected (higher, lower, or no change) if the following occurs? (a) The pH meter was incorrectly calibrated to read lower than the actual pH. (b) During the

  4. Chemistry 12

    9. According to Arrhenius, which of the following groups contain: i)only acids ii)only bases a. NaOH, H2CO3, KCl b. MgCl2, H2SO4, HCl c. HNO3, HCl, H3PO4 d. Mg(OH)2, AgBr, HF e. KOH, NH4OH, Ba(OH)2 10. Enough water is added to 100

You can view more similar questions or ask a new question.