Chemistry

why do crystals from in solutions once removed from the heat e.g. copper sulphate solution or a alum solution

  1. 👍
  2. 👎
  3. 👁
  1. Once the heat is removed and solidification starts, molecules tend to attach to an existing nucleation site in a preferred orientiation and configuration because they "fit better together" that way.

    1. 👍
    2. 👎

Respond to this Question

First Name

Your Response

Similar Questions

  1. science

    why does a candle appear to go out when a copper coil is placed over the flame? Combustion requires three things: fuel (wax here), oxygen (air here), ignition temperature (a match here probably). Remove one and the combustion

  2. science

    The specific heat of copper is 0.092 cal/g °C. If a 590 g copper pan is heated from a temperature of 25 °C to 180 °C, how many calories of heat energy will the copper pan absorb?

  3. CHEMISTRY

    The specific heat of copper is 0.386 J/gºC. A 20.0 g sample of copper is heated from 25.0 ºC to 35.0 ºC. How much heat did the copper absorb?

  4. Chemistry

    A student was asked to prepare a sample of copper(ii)sulphate crystals(CUSO4.5H2O) given 5g of of copper (ii)oxide (CUO) as the starting material.if 10g of dry crystals of CUSO4.5H2O were obtained,calculate the percentage yield???

  1. chemistry

    Calculate the mass of copper (ii) sulphate which needs to be used to prepare 500cm³ of a 0.1M solution.

  2. Chemistry

    A 0.25 M CuSO4 solution is required. A student is given 60 grams of copper sulphate. Calculate the volume of water needed to dissolve copper sulphate crystals and make this solution.

  3. science

    On heating 10grams copper sulphate crystals (CuSO4.5H2O),6.4 grams anhydrous sulphate was left .Find the value of X .

  4. Chemistry

    For each of the following, write a net ionic equation (modeled above). Wherever there is a precipitate, state the name of the precipitate (e.g “lead iodide” from above). Pop onto the net and see if you can find a description

  1. Chemistry

    Starting with copper metal describe how a sample of crystals of copper (ii)chloride may be prepared in the lab

  2. chem

    I had to go and do a oxidation- reduction lab where: I went oxidized borneol with sodium chloride and added 0.360g racemic borneol, 1ml acetone, and .30ml glacial acetic acid. Then I heated and added through the condenser every 4

  3. Chemistry

    I was doing a lab experiment on the reaction of copper(II) sulphate and aluminum: 1) I measured 2.02g of copper(II) sulphate pentahydrate 2) I dissolved the copper(II) sulphate pentahydrate in 10mL of distilled water 3) I added

  4. chemistry

    how much copper sulphate will require saturating 80 grams of water at 20 degree celcious .if solubility of copper sulphate at 20degree celcious is 25?

You can view more similar questions or ask a new question.