I conducted a simple titration experiment and i need to write how and why are the results reproducible can some one help me in answering this.

Thankyou C.

  1. 👍 0
  2. 👎 0
  3. 👁 114

Respond to this Question

First Name

Your Response

Similar Questions

  1. Chemistry

    I had conducted an experiment to figure out the percent by mass of baking soda in a mixture by titration. I had to standardize 1.0M HCl. Through the standardization process and the titration curve of the primary standard and the

    asked by Sandy on April 13, 2014
  2. Chemistry

    In a simple titration experiment how and why are the results reproducible?

    asked by Paul on October 15, 2010
  3. anaytical chemistry

    experiment: potentiomeric titration 1. Why is continuos stirring (use of stirrer and magnetic stir bar)important in potentiometric titration? 2. Why should the increments of addition of titrant be narrowed down as the titration

    asked by :kkk: on September 2, 2007
  4. physics

    does anyone know who conducted the experiment or a credible description of the experiment that helped prove Einstein's thought experiment: the twin paradox? as in the experiment in which one cesium-beam atomic clock stays on

    asked by frank on January 10, 2010
  5. Chemistry

    Help needed for writing up a balance chemical equation for an acid/base titration: for an extended experimental experiment we tested the total acid content of orange juice, then had to write the balanced chemical equation for the

    asked by Lauren on November 3, 2007
  6. Biotechnology

    Consider the titration of 25.0 mL of 0.050 0 M Sn2+ with 0.100 M Fe3+ in 1 M HCl to give Fe2+ and Sn4+, using Pt and calomel electrodes. (a) Write a balanced titration reaction. (b) Write two half-reactions for the indicator

    asked by Minh on December 4, 2016
  7. Science

    I have my results from a simple titration experiment (sodium carbonate against hydrochloric acid) Average titre of 53.27 cm3 which i am happy with but how can i reason that my results are accurate?

    asked by Charlie on October 15, 2010
  8. Chemistry

    Why is it important to keep the NaOH solution (being used during titration) stoppered at all times when it is not in use? And why is it all right to use a wet flask for a titration experiment?

    asked by Cassie on March 26, 2011
  9. chem

    Is there any simple way to predict the volume of a second back titration done on a particular antacid substance after completing a titration the first time around?..Thank you every one for responses.

    asked by kat on November 10, 2011

    During an experiment conducted on the effort E to lift a load W when using a simple the following values were recorded. ………………………………………………………………………………………………

    asked by barotseland network on February 28, 2013

More Similar Questions