electricity

if a bar of copper is brought near a magnet, the copper bar will be? A)attracted by the magnet. B)unaffected by the magnet. C)repelled by the magnet. D)made into an induced magnet.


B)unaffected by the magnet.

Actually there is a very slight repulsn due to diamagnetism (C), but they probably don't expect you to know that.


the bar is unaffected by the magnet


D made into an induced magnet


If a bar of copper is brought neat a magnet, the copper bar will be?

  1. 👍
  2. 👎
  3. 👁
  1. unaffected by the magnet

    1. 👍
    2. 👎

Respond to this Question

First Name

Your Response

Similar Questions

  1. Chemistry

    Naturally occurring copper contains a mixture of 69.09% copper-63 (63.9298 amu) and 30.91% copper-65 (64.9278 amu). What is the average atomic mass of copper?

  2. Chemistry

    Give the formula of each of the following copper minerals: A. cuprite, copper (I) oxide B. chalcocite, copper (I) sulfide C. covellite, copper (II) sulfide

  3. Chemistry

    the diameter of a copper atom is roughly 1.3×10^-10 m. how many times can you divide evenly a piece of 10cm copper wire until it is reduce to two seperate copper atoms? (assume there are appropriate tools for the procedure and

  4. Chemistry

    In chemistry, we did a lab in which we had a certain mass of copper, performed multiple experiments on the copper, and at the end, extracted the copper from a solution and weighed it. The goal was that the mass of the final copper

  1. physics

    The drawing shows a 156-kg crate hanging from the end of a steel bar (S = 8.1 x 1010 N/m2). The length of the bar is 0.117 m, and its cross-sectional area is 7.44 x 10-4 m2. Neglect the weight of the bar itself and determine (a)

  2. Physics

    The substation bus bar is made up of 2-iches round copper bars 20 ft. long. What is the resistance of each bar if resistivity is 1.724 x 10-6 ohm-cm.

  3. Physics

    A bar of aluminum (bar A) is in thermal contact with a bar of iron (bar B) of the same length and area. One end of the compound bar is maintained at Th = 75.5°C while the opposite end is at 30.0°C. Find the temperature at the

  4. chemistry

    using your initial mass of copper, calculate the minimum volume of concentrated 12M nitric acid needed to completely react with your copper to form copper(II) nitrate? Original mass of copper was 0.40g.

  1. physics

    A 52.0 g ball of copper has a net charge of 2.1 µC. What fraction of the copper's electrons have been removed? (Each copper atom has 29 protons, and copper has an atomic mass of 63.5.)

  2. physics

    how long will it take for a 1.5A current to coat evenly a layer of copper 0.1mm thick on both sides of a 12cm by 12cm copper plate(e.c.e of copper is 0.000331gC; density of copper 9gcm?

  3. chemistry

    One of the reactions involved in the smelting of copper sulfide ores involves copper(I) oxide and copper (I) sulfide: 2Cu2O(solid) + Cu2S(solid) ---> 6Cu(solid) + SO2(gas) Assuming that 35.00 g of copper (I) oxide is heated with

  4. Chemistry

    When copper(II) oxide is heated in the presence of hydrogen gas, elemental copper and water are produced. What mass of copper can be obtained if 34.0 g copper(II) oxide is used?

You can view more similar questions or ask a new question.