# calculus

a 100 pound collar slides on a frictionless vertical rod. find the distance y for which the system is in equilibrium if the counterweight weights 120 pounds.

1. 👍
2. 👎
3. 👁
1. I have no idea without seeing the geometry of the situation.

1. 👍
2. 👎
2. thanks

1. 👍
2. 👎

## Similar Questions

1. ### Physics

Block 1 of mass m1 slides from rest along a frictionless ramp from height h and then collides with stationary block 2, which has mass m2 = 3m1. After the collision, block 2 slides into a region where the coefficient of kinetic

2. ### physics

A thin rod has a length of 0.25 m and rotates in a circle on a frictionless tabletop. The axis is perpendicular to the length of the rod at one of its ends. The rod has an angular velocity of 0.33 rad/s and a moment of inertia of

3. ### AP PHYSICS MECH.

Need help urgent!!! A system consist of a ball of M2 and a uniform rod of M1 and length d. The rod is attached to a horizontal frictionless rotates at an angular speed w, as shown in the figure. The rotational inertia of the rod

4. ### physics

The figure shows an overhead view of a 3.00-kg plastic rod of length 1.20 m on a table. One end of the rod is attached to the table, and the rod is free to pivot about this point without friction. A disk of mass 37.0 g slides

1. ### Physics

A massless rod of length L = 3.6 m stands up straight, fixed to the ground by a bolt. A horizontal force of 5.5 N is applied at a vertical distance of L/2 to the right. To counter this force and keep the rod stationary, a wire is

2. ### Physics

A nonuniform 2.0-kg rod is 2.0 m long. The rod is mounted to rotate freely about a horizontal axis perpendicular to the rod that passes through one end of the rod. The moment of inertia of the rod about this axis is 4.0 kg m2. The

3. ### Physics 202

A rail gun uses electromagnetic forces to accelerate a projectile to very high velocities. The basic mechanism of acceleration is relatively simple and can be illustrated in the following example. A metal rod of mass 10.0g and

4. ### physics

A piece of putty of mass m = 0.75 kg and velocity v = 2.5 m/s moves on a horizontal frictionless surface. It collides with and sticks to a rod of mass M = 2 kg and length L = 0.9 m which pivots about a fixed vertical axis at the

1. ### AP Physics

A uniform thin rod of length 0.3m and mass 3.5kg can rotate in a horizontal plane about a vertical axis through its center. The rod is at rest when a 3g bullet traveling in the horizontal plane of the rod is fired into one end of

2. ### physics

In Figure 8-50, a block slides along a track from one level to a higher level after passing through an intermediate valley. The track is frictionless until the block reaches the higher level, where a frictional force stops the

3. ### physics

2. Rod A, which is 30 cm long, expands by 0.045 cm when heated from 0°C to 100°C. Rod B, also 30 cm long expands by 0.075 cm for the same change in temperature. A third Rod C, also 30 cm long is made up of the materials of rod A

4. ### physics

A metal rod of mass m slides without friction along two parallel horizontal rails separated by a distance L and connected by a resistor R. A uniform magnetic field of magnitude B is applied perpendicular to the plane of the paper.