Chemistry

Why is a NaOH solution disposed differently than a solution composed of Water and Nacl2

  1. 👍
  2. 👎
  3. 👁
  1. NaOH is a strong base. It sole as lye in stores and it is VERY caustic. Water and NaCl are neutral and not likely to cause any damage.

    1. 👍
    2. 👎

Respond to this Question

First Name

Your Response

Similar Questions

  1. college chemistry

    When a solution containing 8.00 g NaOH in 50.0 g of water at 25 °C is added to a solution of 8.00 g of HCl in 250.0 g of water at 25 °C in a calorimeter, the temperature of the solution increases to 33.5 °C. Assuming that the

  2. acid-base titrations

    For each of the following circumstances, indicate whether the calculated molarity of NaOH would be lower, higher or unaffected. Explain your answer in each case. a.the inside of the pipet used to transfer the standard HCI solution

  3. Chemistry

    I'm trying to find the solubility of Ca(OH)2 in .0125 mol/L aqueous NaOH. Here is my data: Vol of solution used per titration: 20mL Conc of HCl: .1201 mol/L Average Titre: 4.71 I need to calculte: 1. the TOTAL [OH-] in the

  4. AP Chemistry

    A 2.685 g sample of KHC8H4O4 was dissolved in water and uses to standardize a NaOH solution. The endpoint was reached after 38.25mL of titrant were delivered. Find the molar concentration of the NaOH solution.

  1. Chemistry

    What is the molality of a glucose solution prepared by dissolving 18.0g of glucose, C6H12O6 in 125g of water? A)0.000794 B)0.144 C)0.699 D)0.794 Molality is the number of moles of solute per kilogram of solvent. Because the

  2. chemistry

    1. When performing this experiment, a student mistakenly used impure KHP to standardize the NaOH solution. If the impurity is neither acidic nor basic, will the percent by mass of acetic acid in the vinegar solution determined by

  3. Chem.

    To standardize a solution of NaOH, one uses a primary standard called potassium hydrogen phthalate (KHP). It is a monoprotic acid. It has a molar mass of 204.33g/mol. Suppose you weigh out .556g of KHP and dissolve it in water. It

  4. Chem 2

    What is the molarity of a solution composed of 8.210g of Potassium Chromate (K2CrO4),dissolved in enough water to make .500 L of solution

  1. Chemistry

    One commercial method used to peel potatoes is to soak them in a solution of NaOH for a short time, remove them from the NaOH, and spray off the peel. The concentration of NaOH is normally in the range of 3 to 6 M. The NaOH is

  2. Chemistry

    Use the dilution relationship (Mi x Vi = Mf x Vf) to calculate the volume of 0.500 M NaOH needed to prepare 500 mL of .250 M NaOH. This is my work ? L Solution = 500mL x (1L/1000mL) = .500L ? mol NaOH = .500 L Solution x (0.250 M

  3. Mole fraction of a vapor pressure?

    If 0.380 mol of a nonvolatile nonelectrolyte are dissolved in 3.00 mol of water, what is the vapor pressure P(H2O) of the resulting solution? The vapor pressure of pure water is 23.8 torr at 25 C. I got this answer correct: 21.1

  4. Chemistry

    1. You have been given a sample of unknown molarity. Calculate the molarity of a solution which has been prepared by dissolving 8.75 moles of sodium chloride in enough water to produce a solution of 6.22l. 2. You have a sample

You can view more similar questions or ask a new question.