Chemistry

A 25.00-mL sample of an H2SO4 (2 and 4 are subscripted) solution of unknown concentration is titrated with a .1328 M KOH solution. A volume of 38.33 mL of KOH was required to reach the endpoint. What is the concentration of the unknown H2SO4 (again, the 2 and 4 are subscripted) solution?

my work:
38.33 mL KOH* (1L/1000mL)*(.1328 M KOH/L KOH)*(1 mol H2SO4/1mol KOH)=.005090 mol H2SO4

M= mol solution/L= .005090mol/.025L
=.2036M

However, the answer in the book says it should equal .1018M. I'm confused.

  1. 👍
  2. 👎
  3. 👁
  1. I'm sorry... I accidently reposted this--it is not answered yet though.

    1. 👍
    2. 👎
  2. look at you last ( ). If you balance the reaction, you will find it takes 2mol KOH to neutralize one mole of H2SO4

    1. 👍
    2. 👎
    👤
    bobpursley

Respond to this Question

First Name

Your Response

Similar Questions

  1. Chemistry

    The titration of 25.0 mL of an unknown concentration H2SO4 solution requires 83.6 mL of 0.12 M LiOH solution. What is the concentration of the H2SO4 solution (in M)? A) 0.40 M B) 0.10 M C) 0.20 M D) 0.25 M E) 0.36 M The answer is

  2. chemistry

    CH3NH2(aq)+H2O(l)=>CH3NH3+(aq)+OH-(aq) Kb=4.4 x 10^-4 Methylamine, CH3NH2, is a weak base that reacts with water according to the equation above. A student obtains a 50.0 mL sample of a methylamine solution and determines the pH

  3. Analytical chemistry

    A 25.0-mL solution of 0.0660 M EDTA was added to a 33.0-mL sample containing an unknown concentration of V3 . All V3 present formed a complex, leaving excess EDTA in solution. This solution was back-titrated with a 0.0450 M Ga3

  4. chemistry 112

    A volume of 60.0mL of aqueous potassium hydroxide (KOH) was titrated against a standard solution of sulfuric acid (H2SO4). What was the molarity of the KOH solution if 19.2mL of 1.50 M H2SO4 was needed? The equation is

  1. Chemistry

    One commercial method used to peel potatoes is to soak them in a solution of NaOH for a short time, remove them from the NaOH, and spray off the peel. The concentration of NaOH is normally in the range of 3 to 6 M. The NaOH is

  2. chemistry

    A 27.00 mL sample of an unknown H3PO4 solution is titrated with a 0.110 M NaOH solution. The equivalence point is reached when 25.78 mL of NaOH solution is added. What is the concentration of the unknown H3PO4 solution? The

  3. chemistry

    30 ml of sample of unknown strong base is neutralized after the addition of 12 ml of a 0.150 M HNO3 solution if the unknown base concentration 0.0300 M give the possible identities for the unknown base

  4. Chemistry

    15.00mL sample of a solution of H2SO4 of unknown concentration was titrated with 0.3200 N NaOH. The titration required 21.30mL of the base. What was the normality of the acid solution? what was the molarity of the acid solution?

  1. Chemistry

    A 29.00 mL sample of an unknown H3PO4 solution is titrated with a 0.100 M NaOH solution. The equivalence point is reached when 24.63 mL of NaOH solution is added? What is the concentration of the unknown H3PO4 solution? The

  2. chemistry

    The densities of three solutions with known concentrations ( 20% , 50%, and 70%), and one unknown solution were determined. If the densities of 20%, 50% and 70% solutions are 0.69 and 0.58 and 0.49 g/mL, respectively, and the

  3. Chemistry

    A is a solution of trioxonitrate (v)acid, HNO3 of unknown concentration.B is standard solution of sodium hydroxide containing 4.00g per dm3 of solution. 25 cm3 portion solution B required an average of 24.00cm3 of solution A for

  4. chemistry

    When the glucose solution described in part A is connected to an unknown solution via a semipermeable membrane, the unknown solution level rises. Based on this information, what can be said about these two solutions? a.) The

You can view more similar questions or ask a new question.