Questions LLC
Login
or
Sign Up
Ask a New Question
Science
Physics
A Petrol Engine Raises 200litres Of Water In A Well From A Depth Of 7m In 6 Sec.What Is The Power Of The Engine? hint=1m=1000L,w=p
1 answer
power = work/time = force*distance/time
so plug in your numbers
You can
ask a new question
or
answer this question
.
Similar Questions
A Petrol Engine Raises 200litres Of Water In A Well From A Depth Of 7m In 6 Sec.What Is The Power Of The Engine?
Top answer:
p=w/t W=Mgh 1litir=1kg 200L=200kg W=200kg*9.81m/s^2*7m W=13734j P=13734/6 P=2289watt
Read more.
A petrol engine raises 200 kg of water in a well from a depth of 7 m in 6 s. Show that the engine is developing about 2.33 KW of
Top answer:
power = work/time = force*distance/time = mgh/t 200*9.81 * 7 / 6 = 2289 W
Read more.
A petrol engine raises 200 litres of water in a well from a depth of 7 m in 6 seconds. Show that the power of the engine is
Top answer:
Power = Work/Time Work = Force x Distance Force = Mass x Acceleration Mass = Volume x Density Volume
Read more.
a petrol engine raises 200 liters of water in a well from a depth of 7m in 6seconds show that the power of the engine is about
Top answer:
rather than just whining for an answer, did you try to solve the problem? power = work/time =
Read more.
A piston engine raises 200 liters of water in a wall from a depth of 7m in 6 seconds. find the power of the engine .the density
Top answer:
power = work/time = force*distance/time (200L * 1kg/L * 9.81 N/kg) * 7m / 6s = ____ W
Read more.
1.an engine develops 65kW over a period of 20minutes. The engine uses 5kg of petrol.
Calculate the following:- A. The heat
Top answer:
1. To calculate the requested values in this problem, we will use some basic formulas from physics.
Read more.
1.an engine develops 65kW over a period of 20minutes. The engine uses 5kg of petrol.
Calculate the following:- A. The heat
Top answer:
1. A. To calculate the heat generated, we can use the formula: Heat = Power × Time Given that the
Read more.
An engine raises 100kg of water through a height of 60m in 20sec. What is the power of the engine. (Take g=10m/s^2
Top answer:
m=100kg h=60m t=20s p=? p=work \time =f×d\time =mg×h\t =100×10×60\20= 3000
Read more.
An engine draws water from a depth of 10 m from earth at aspeed of 2m/s at arate of 10 kg/10 s. What is the power of the engine?
Top answer:
To determine the power of the engine, we need to use the formula: Power (P) = work done (W) / time
Read more.
What is the difference between petrol engine and diesel engine
Top answer:
The main differences between petrol engines and diesel engines are as follows: 1. Fuel: The most
Read more.
Related Questions
A mass 20.0g of petrol was burnt in air. The heat produced was used to heat 2.5 litres of water. Given that the heat value of
a car petrol tank in 0.8m long 25cm wide and 20cm deep.how many litres of petrol can it hold?
A mass has 20.0g of petrol was burnt in air the heat produce wlalsl usedto heat 2.5litter of water given that
the heat value of
you are designing a diving bell to withstand the pressure of sea water at a depth of 250m. a)what is the quage pressure at the
A bus uses 18 litres of petrol to travel 90 km. At the same rate of consumption, calculate the amount of petrol needed for a 200
On a typical day at an ocean port, the water has a maximum depth of 20m at 8:00AM. The minimum depth of 8m occurs 6.2h later.
The depth d of water in a tank oscillates sinusoidally once every
4 hours. If the smallest depth is 7.9 feet and the largest
A cylindrical container of 15cm and depth of 20cm is full of water.If the water is poured into a empty cylinder jar of 10cm in
The average depth of the water in a port on a tidal river is 4 m. At low tide, the depth of the water is 2 m. One cycle is
The average depth of the water in a port on a tidal river is 4m. At low tide, the depth of the water is 2m. One cycle is