science

A tuning fork vibrating at 200 Hz is placed under water. If sound travels 1500 m/s through water, what is the wavelength of this sound wave?

300,000 m
7.5 m
0.13 m
1300 m

  1. 👍 0
  2. 👎 0
  3. 👁 99
  1. v= frq x wavelenth
    1500 m/s = 200 hz * wavelength

  2. It is B, thank you.

    1. 👍 0
    2. 👎 0
  3. I would pick that.

Respond to this Question

First Name

Your Response

Similar Questions

  1. Physics

    The tine of a tuning fork, when struck, has an amplitude of 0.13 cm. If the frequency of the fork is 200 Hz, what total distance will the tine travel in 1.0 minute?

    asked by HanuPhys26/11 on November 26, 2012
  2. Physics

    A tuning fork has been damaged and its frequency slightly changed. What could its altered frequency be if it produces two beats per second with a tuning fork that is known to vibrate at 422 Hz? Lowest frequency? Highest frequency?

    asked by Helen on April 21, 2012
  3. Physics

    The speed of sound in a classroom is 343m/s. A) A tuning fork of frequency 512Hz is struck. What length of open air tube is required to create a resonant sound at the 1st harmonic? wavelength=v/f=343/512=0.67m

    asked by Kayla on June 11, 2017
  4. Physics

    The water level in a vertical glass tube 1.40 m long can be adjusted to any position in the tube. A tuning fork vibrating at 440 Hz is held just over the open top end of the tube, to set up a standing wave of sound in the

    asked by Emma on May 25, 2011
  5. Physics

    If you fasten lumps of clay on the prongs of a tuning fork, does this change the amount of moving mass? Does it change the stiffness of the pongs? Explain then whether the fork's natural frequency of oscillation is increased or

    asked by anymouns on February 2, 2012
  1. Physics waves

    1. A vibrating point on a spring travels 60 mm during three cycles. What is the amplitude of the vibration? a) 0.05 mm b) 5.0 mm c) 15.mm d) 20.mm e) 180 mm my answer: I got 10 mm but it is not listed as an option 2. When a tuning

    asked by Liz on May 1, 2014
  2. Physics

    When a tuning fork of unknown frequency is sounded simultaneously with a 512 Hz tuning fork, 20 beats are heard in 4.0 seconds. What are the possible frequencies of the unknown tuning fork?

    asked by Liz on May 2, 2014
  3. Physics

    A tuning fork of frequency 500 Hz is rotating on the edge of a disk of radius 1.2 meters. a) If the disk turns at a rate of 40 rev/min, what are the maximum and minimum frequencies heard by the listener? b) To what positions of

    asked by Abbi on January 27, 2013
  4. Physics

    When two tuning forks are stuck simultaneously, 3 beats per second are heard. The frequency of one fork is 510 Hz. A piece of wax is placed on the 510 Hz fork to lower its frequency slightly. If the beat frequency is increased,

    asked by dallas on May 15, 2013
  5. Physics

    To demonstrate standing waves, one end of a string is attached to a tuning fork with frequency 120 Hz. The other end of the string passes over a pulley and is connected to a suspended mass M, as shown. The value of M is such that

    asked by AJ on October 1, 2012

You can view more similar questions or ask a new question.