boiling point determination

Explain why a rapid stream of bubbles comes out of the bell tube as the sample reaches its boiling point temperature?

Explain why liquid runs up the empty bell tube as the sample is cooled back down to its boiling point temperature?

  1. 0
  2. 0
  3. 15
asked by alex034
  1. What are you doing in this experiment?

    1. 0
    2. 0
    posted by DrBob222

Respond to this Question

First Name

Your Response

Similar Questions

  1. chemistry

    I am enrolled in analytical chemistry after a 4 year break from any chemistry. I was recently given a problem set and I need some help on the following: A 0.899g sample containing epsom salt, MgSO4 & 7 H2O, and other non-hydrated

    asked by Kenneth on January 30, 2008
  2. Ap Bio

    SAME LAb - Collect a sample of water below some riffles in stream. Stream runs into a lake. 2nd sample from lake. Which smaple would you expect to have the higher DO? Explain

    asked by kelly on September 24, 2008
  3. gravimetric prob

    A pure organic compound weighing 947.4mg was heated in a stream of oxygen. The effluent gas was swept successively through a tube of magnesium perchlorate dessicant weighing 18.6137g and a tube of Ascarite weighing 16.8425g. After

    asked by vivian on April 20, 2015
  4. Chemistry

    1) When calcium is reacted with cold water, the equation is as follows: - Ca(s) + H2O(l) -->Ca(OH)2(aq) + H2(g) Isn't Ca(OH)2 insoluble? Why is the state symbol aqueous? When I conducted the experiment in a test tube with cold

    asked by candy on January 31, 2009
  5. chem

    What effect would each of the following have on a sample'sobserved melting-point range ? b.rapid heating c.use of so much sample that the filled portion of the capillary tube extents considerably beyond the thermometer bulb d.poor

    asked by loren on September 16, 2011
  6. Science

    Suppose that you heated a sample of a hydrated ionic compound in a test tube. What might you expect to see inside the test tube, near the top of the test tube? Explain please i really am stumped on this question...

    asked by katie on December 1, 2014
  7. Chem

    A gas generator is constructed to collect the CO2(g) evolved from a reaction. during lab we set up the CO2 generator by placing 10ml of 3 M HCL in a 200mm test tube. then slide the 75mm test tube into the 200mm test tube without

    asked by Ben on November 16, 2011
  8. physics

    Using the circuit for an electric bell, a) Explain why the bell won't work if the elctromagnet is replaced with a permanent magnet. (2 marks) b)Explain why the core of the electromagnet used in an electric bell must not be made

    asked by anonymous on March 12, 2011
  9. physics

    Using the circuit for an electric bell, a) Explain why the bell won't work if the elctromagnet is replaced with a permanent magnet. (2 marks) b)Explain why the core of the electromagnet used in an electric bell must not be made

    asked by anonymous on March 12, 2011
  10. Science-Chemistry

    Analysis questions: A) What evidence is there that the gas bubbles formed in the first part of the investigation were hydrogen gas? Answer: Evidence there was that proved that the gas bubbles formed in the first part of the

    asked by Immy on September 14, 2010

More Similar Questions