physics

A force of 40N is applied at the end of a wire 4m long and it produces an extension of 0.24mm.if the diameter of the wire is 2.0mm.calculate the stress and strain of the wire

  1. 0
  2. 0
  3. 20
asked by Lola
  1. 23

    1. 0
    2. 0
    posted by Ff
  2. force of 40N is applied at the end of a wire 4m long and it produces an extension of 0.24mm.if the diameter of the wire is 2.0mm.calculate the stress and strain of the wire

    1. 0
    2. 0
    posted by Matthew

Respond to this Question

First Name

Your Response

Similar Questions

  1. PHYSICS

    A FORCE OF 40N IS Applied at the end of wire 4m long and produced an extention of 0.24mm if the diameter of wire is 2.00mm.calculate stress on wire and strain in the wire
  2. physics

    A force of 40N is applied at the end of a wire 4m long and produces an extension of 0.24mm. If the diameter of the wire is 2.00mm calculate the stress on the wire and strain in the wire. With full workings please
  3. physics

    A circular steel wire 2.00 m is to stretch no more than 0.25 cm when a tensile force of 400 N is applied to each end of wire. What minimum diameter is required for the wire?
  4. Physics

    A weight of 40N was attached to the end of a wire during modulus experiment, if the length of the wire is 4m and the diameter is 0.44mm and the extension recorded is 0.30mm. calculate the stress and strain of the wire?.
  5. vectors

    A steel wire 40 m long is suspended between two fixed points 20 m apart. A force of 375 N pulls the wire down at a point 15 m from one end of the wire. State the tension in each part of the wire. Texbook answer: 375N, 0N
  6. Science

    a student made an electromagnet using a battery electrical tape and metal wire. she wanted to see what the effect would be if she switched the side of the battery she connected each end of the wire to. which of the following would
  7. College Physics

    One end of a 14 m long wire having a total mass of .8000 kg is fastened to a fixed support in the ceiling, and a 7.50 kg object is hung from the other end. If the wire is struck a transverse blow at one end, how much time does the
  8. Physics

    A force of 32 N is applied at the end of a wrench handle that is 27 cm long. The force is applied in a direction perpendicular to the handle as in the diagram. (a) What is the torque applied to the nut by the wrench? (b) What
  9. physics

    The current-density magnitude in a certain circular wire is J = (2.75 × 10 10 ⁄ )r 2 , where r is the radial distance out to the wire’s radius of 3.00 mm. The potential applied to the wire (end to end) is 60.0 V. How much
  10. Physics

    A force of 100 N is applied straight down to lower a handle from 45˚ above the horizontal to 45˚ below it. The handle is 1 m long and the force is applied at its end throughout the motion. What is the rate of change of the

More Similar Questions