# Science

A 50-kg block is being pulled up a 30.0^ slope by force of 250N which is parallel to the slope, but the block does not slide up the slope. What is the minimum value of the coefficient of static friction required for this to happen?

1. 👍 0
2. 👎 0
3. 👁 248
1. M*g = 50 * 9.8 = 490 N. = Wt. of block. = Normal force(Fn).

Fp = 490*sin30 = 245 N. = Force parallel with the incline.

Fs = u*Fn = u * 490 = 490u.

Fap-Fp-uFn = M*a.
250 - 245 - 490u = M*0 = 0,
u = 0.010.

1. 👍 0
2. 👎 0

## Similar Questions

1. ### Science

A 20 kg block rests on a rough horizontal table. A rope is attached to the block and is pulled with a force of 80 N to the left. As a result, the block accelerates at 2.5 m/s2. The coefficient of kinetic friction μk between the

2. ### physics, Bauchi State University

10kg block rest on top of a 40kg slap which rest on a frictionless flow. the coefficient of static and friction between the block and the slap are 9.60 and 0.40 respectively. the block is pulled with a force of 100 Newton. what

3. ### physics

A 3.90 kg block located on a horizontal frictionless floor is pulled by a cord that exerts a force F=14.1N at an angle theta=32.5degrees above the horizontal, as shown. a.) What is the magnitude of the acceleration of the block

4. ### Physics

A 3.0 kg block being pulled across a table by a horizontal force of 80 N also experiences a frictional force of 5 N. What is the acceleration of the block?

1. ### physics

A 50.0-kg block is being pulled up a 13 degree slope by a force of 250 N which is parallel to the slope. The coefficient of kinetic friction between the block and the slope is 0.200. What is the acceleration of the block?

2. ### Physics

A block of mass 57.1 kg rests on a slope having an angle of elevation of 28.3°. If pushing downhill on the block with a force just exceeding 162 N and parallel to the slope is sufficient to cause the block to start moving, find

3. ### physics

A 3.24 kg block located on a horizontal frictionless floor is pulled by a cord that exerts a force F=11.8N at an angle theta=23.0degrees above the horizontal, as shown. What is the magnitude of the acceleration of the block when

4. ### science

A steel block weighing 12N is pulled up an incline plane 20° above the horizontal by a constant force of 7.35 N which makes an angle of 10° above the inclined plane. The block stars from rest and is pulled 2.0m along the

1. ### Physics

A 5.1–kg block is pulled along a frictionless floor by a cord that exerts a force P = 12 N at an angle θ = 25° above the horizontal, as shown below. (a) What is the acceleration of the block? (b) The force P is slowly