Physical Science

An experiment was done. Pulling blocks of mass that were certain amounts of newtons. There were 2 tests done. However, they varied by a couple decimals after the second test.

The results from the two tests differ slightly. Which would most likely cause the
variations in these results?
A. pulling the masses too slowly
B. the precision of the measuring devices
C. air resistance experienced while pulling the masses
D. decreasing the surface friction for the second test of each mass

I think c. please correct me. Thx

asked by Marcus Peerbocus
  1. it is C

    posted by ds

Respond to this Question

First Name

Your Response

Similar Questions

  1. Physical Science

    An experiment was done. Pulling blocks of mass that were certain amounts of newtons. There were 2 tests done. However, they varied by a couple decimals after the second test. The results from the two tests differ slightly. Which
  2. Physics

    Can someone help me with this problem? It requires a lot of visualizing and I've never been great at problems like that. A pair of blocks of mass m1 =29.0 kg, and m2 =58.0 kg, are being pushed on a horizontal surface by a constant
  3. Physics

    Three blocks are located on a horizontal frictionless table. They are connected by a massless cord, as shown in the figure, and pulled to the right. The masses of the three blocks are m1 = 22 kg, m2 = 21 kg, and m3 = 33 kg. The
  4. Physics

    Two fraternities are in a tug of war. Theta Chi is pulling with a total force of 4,748 newtons to the east and Tau Kappa is pulling with a total force of 3,969 newtons to the west. What is the magnitude and direction of the
  5. PHYSICS

    Two blocks of mass m1 = 320 g and m2 = 725 g are pushed by a force. The coefficient of kinetic friction between each block and the ground is 0.4. The blocks move together (with one pushing the other) with an acceleration of 225
  6. physics

    A series of two 2.0 kg blocks are attached together through string B.Two of the blocks weigh each 2.0 kg and are now being use for a new experiment. The blocks are being pulled upwards by another string A with a force of 25 N.
  7. physics

    A series of two 2.0 kg blocks are attached together through string B.Two of the blocks weigh each 2.0 kg and are now being use for a new experiment. The blocks are being pulled upwards by another string A with a force of 25 N.
  8. physics

    Three blocks are located on a horizontal table. The coefficient of kinetic friction between the blocks and the table is 0.276. They are connected by a massless cord, as shown in the figure below, and pulled to the right. The
  9. Physics

    Two blocks are in contact on a horizontal, frictionless table. Block 1 has a mass of 4.39 kg and block 2 has a mass of 2.59 kg. A horizontal force of magnitude 8.25 N is applied to the one of the blocks. Find the magnitude of the
  10. physics- please help

    World-class sprinters can accelerate out of the starting blocks with an acceleration that is nearly horizontal and has magnitude 15m/s^2 . Part a)How much horizontal force F must a sprinter of mass 60kg exert on the starting

More Similar Questions