physics

1.) Water flows from a 2 cm diameter pipe, at a speed of 0.35m/sec. How long will it take to fill a 10 liter container?

2.) A horizontal segment of pipe tapers from a cross-sectional area of 50 cm^2 to 0.5 cm? The pressure at the larger end of the pipe is 1.2x 10^5 Pa and the speed is 0.04m/sec. What is the pressure at the narrow end of the segment?

thanks. :)

  1. 👍
  2. 👎
  3. 👁
  1. 1. Volume flow rate = (Area)(Velocity) = pi*2^2/4 V = pi cm^2* 35 cm/s = 110 cm^3/s
    Amount filled = V = 10,000 cm^3 = Q t
    t = V/Q = 10,000 cm^2/(110 cm^3/s)
    = ? s

    2. Use the incompressible continuity equation V*A = constant to get the velocity at the narroqw end. Velocity will be 100 times higher at the narrow end. Then apply Bernoulli's equation for the pressure change.
    P + (1/2)*(density)*V^2 = constant
    P2 - P1 = (1/2)(density)(V1^2 - V2^2)

    1. 👍
    2. 👎
  2. thanks for your help. :)

    1. 👍
    2. 👎

Respond to this Question

First Name

Your Response

Similar Questions

  1. Physics

    Please someone help..A horizontal pipe 10.0cm in diameter has a smooth reduction to a pipe 5.0cm in diameter. If the pressure of the water in the large pipe is 80000Pa and the pressure in the small pipe is 60000Pa at what rate

  2. Physics help please**

    A water pipe having a 2.1 cm inside diameter carries water into the basement of a house at a speed of 0.88 m/s and a pressure of 169 kPa. The pipe tapers to 1.0 cm and rises to the second floor 7.1 m above the input point. (a)

  3. Physic

    1. Water at a pressure of 3.00 x 10 5th Pa flows through a horizontal pipe at a speed of 1.00 m/s. The pipe narrows to one-fourth its original diameter. What is the speed of the flow in the narrow section? Not sure was

  4. physics

    The water supply of a building is fed through a main entrance pipe 6cm in diameter. A 2cm diameter faucet tap positioned 2m above the main pipe fills a 25 liter container in 30s. (a) What is the speed at which the water leaves the

  1. physics

    A round pipe of varying diameter carries petroleum from a wellhead to a refinery. At the wellhead the pipe's diameter is 56.3 cm (0.563 m) and the flow speed of the petroleum is 13.5 m/s. At the refinery the petroleum flows at

  2. Physics

    Water flows at a speed of 15 m/s through a pipe that has a radius of 0.40 m. The water then flows through a smaller pipe at a speed of 45 m/s. What is the radius of the smaller pipe?

  3. physics

    Water moves through a constricted pipe in steady, ideal flow. At the lower point shown in figure below, the pressure is P1 = 1.75X104 Pa and the pipe diameter is 6.00 cm. At another point y = 0.250 m higher, the pressure is P2 =

  4. physics

    Water flowing through a 1.9-cm-diameter pipe can fill a 500L bathtub in 5.1min. What is the speed of the water in the pipe?

  1. Physics

    The water flowing through a 1.9 cm (inside diameter) pipe flows out through three 1.3 cm pipes. (a) If the flow rates in the three smaller pipes are 24, 18, and 13 L/min, what is the flow rate in the 1.9 cm pipe? (b) What is the

  2. maths

    Q: oil flows through a pipe at a rate of 40m3/sec. how long will it take to fill a tank of volume 1.2x10^5m3?

  3. physics

    A liquid of density 1354 kg/m^3 flows with speed 2.45 m/s into a pipe of diameter 0.29 m. The diameter of the pipe decreases to 0.05 m at its exit end. The exit end of the pipe is 7.82 m lower than the entrance of the pipe, and

  4. AP Physics - Fluids

    A 6.0-cm diameter horizontal pipe gradually narrows to 4.0 cm. When water flows through this pipe at a certain rate, the gauge pressure in these two sections is 32 kPa and 24 kPa, respectively. What is the volume rate of flow? I

You can view more similar questions or ask a new question.